@@ -27,9 +27,9 @@
#define EN BIT(0)
#define SW_RST BIT(1)
#define SENSOR0_EN BIT(3)
+#define MEASURE_PERIOD BIT(18)
#define SLP_CLK_ENA BIT(26)
#define SLP_CLK_ENA_8660 BIT(24)
-#define MEASURE_PERIOD 1
#define SENSOR0_SHIFT 3
/* INT_STATUS_ADDR bitmasks */
@@ -132,11 +132,26 @@ static int enable_8960(struct tsens_priv *priv, int id)
if (ret)
return ret;
- mask = BIT(id + SENSOR0_SHIFT);
+ /* HARDWARE BUG:
+ * On platform with more than 5 sensors, all the remaining
+ * sensors needs to be enabled all togheder or underfined
+ * results are expected. (Sensor 6-7 disabled, Sensor 3
+ * disabled...) In the original driver, all the sensors
+ * are enabled in one step hence this bug is not triggered.
+ */
+ if (id > 5)
+ mask = GENMASK(10, 6);
+ else
+ mask = BIT(id);
+
+ mask <<= SENSOR0_SHIFT;
+
ret = regmap_write(priv->tm_map, CNTL_ADDR, reg | SW_RST);
if (ret)
return ret;
+ reg |= MEASURE_PERIOD;
+
if (priv->num_sensors > 1)
reg |= mask | SLP_CLK_ENA | EN;
else
It's present a hardware bug in tsens VER_0 where if sensors upper to id 6 are enabled selectively, underfined results are expected. Fix this by enabling all the remaining sensor in one step. Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com> --- drivers/thermal/qcom/tsens-8960.c | 19 +++++++++++++++++-- 1 file changed, 17 insertions(+), 2 deletions(-)