@@ -63,6 +63,42 @@
};
+&cpu_thermal {
+ polling-delay-passive = <100>;
+ polling-delay = <1000>;
+ thermal-sensors = <&tsadc 0>;
+ sustainable-power = <1550>;
+
+ trips {
+ cpu_alert0: cpu_alert0 {
+ temperature = <65000>;
+ hysteresis = <2000>;
+ type = "passive";
+ };
+
+ cpu_alert1: cpu_alert1 {
+ temperature = <75000>;
+ hysteresis = <2000>;
+ type = "passive";
+ };
+
+ cpu_crit: cpu_crit {
+ temperature = <95000>;
+ hysteresis = <2000>;
+ type = "critical";
+ };
+ };
+
+ cooling-maps {
+ map0 {
+ trip = <&cpu_alert1>;
+ cooling-device =
+ <&cpu_b0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
+ <&cpu_b1 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
+ };
+ };
+};
+
&pcie0 {
ep-gpios = <&gpio2 RK_PA2 GPIO_ACTIVE_HIGH>;
};
@@ -125,45 +161,6 @@
status = "okay";
};
-&thermal_zones {
- cpu_thermal: cpu-thermal {
- polling-delay-passive = <100>;
- polling-delay = <1000>;
- thermal-sensors = <&tsadc 0>;
- sustainable-power = <1550>;
-
- trips {
- cpu_alert0: cpu_alert0 {
- temperature = <65000>;
- hysteresis = <2000>;
- type = "passive";
- };
-
- cpu_alert1: cpu_alert1 {
- temperature = <75000>;
- hysteresis = <2000>;
- type = "passive";
- };
-
- cpu_crit: cpu_crit {
- temperature = <95000>;
- hysteresis = <2000>;
- type = "critical";
- };
- };
-
- cooling-maps {
- map0 {
-
- trip = <&cpu_alert1>;
- cooling-device =
- <&cpu_b0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
- <&cpu_b1 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
- };
- };
- };
-};
-
&usbdrd_dwc3_0 {
dr_mode = "otg";
};
The cpu_thermal node in the rk3399-rock960.dts file does not reference &cpu_thermal directly to add the board-specific parts, but also repeats all the SoC default properties. Clean the whole thing up and fix alignment. Place node in the correct alphabetical order. Suggested-by: Robin Murphy <robin.murphy@arm.com> Signed-off-by: Johan Jonker <jbx6244@gmail.com> --- arch/arm64/boot/dts/rockchip/rk3399-rock960.dts | 75 ++++++++++++------------- 1 file changed, 36 insertions(+), 39 deletions(-)