| Message ID | ff78772b306411e145769c46d4090554344db41e.1607363522.git.stefan@agner.ch |
|---|---|
| State | Accepted |
| Commit | 656ab1bdcd2b755dc161a9774201100d5bf74b8d |
| Headers | show |
| Series | [v3,1/5] arm64: dts: meson: g12b: odroid-n2: fix PHY deassert timing requirements | expand |
diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts index 0c26467de4d0..5963566dbcc9 100644 --- a/arch/arm/boot/dts/meson8b-odroidc1.dts +++ b/arch/arm/boot/dts/meson8b-odroidc1.dts @@ -224,7 +224,7 @@ eth_phy: ethernet-phy@0 { reg = <0>; reset-assert-us = <10000>; - reset-deassert-us = <30000>; + reset-deassert-us = <80000>; reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>; interrupt-parent = <&gpio_intc>; diff --git a/arch/arm/boot/dts/meson8m2-mxiii-plus.dts b/arch/arm/boot/dts/meson8m2-mxiii-plus.dts index cc498191ddd1..8f4eb1ed4581 100644 --- a/arch/arm/boot/dts/meson8m2-mxiii-plus.dts +++ b/arch/arm/boot/dts/meson8m2-mxiii-plus.dts @@ -81,7 +81,7 @@ eth_phy0: ethernet-phy@0 { reg = <0>; reset-assert-us = <10000>; - reset-deassert-us = <30000>; + reset-deassert-us = <80000>; reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>; }; };
According to the datasheet (Rev. 1.9) the RTL8211F requires at least 72ms "for internal circuits settling time" before accessing the PHY registers. On similar boards with the same PHY this fixes an issue where Ethernet link would not come up when using ip link set down/up. Fixes: a2c6e82e5341 ("ARM: dts: meson: switch to the generic Ethernet PHY reset bindings") Reviewed-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> Tested-by: Martin Blumenstingl <martin.blumenstingl@googlemail.com> # on Odroid-C1+ Signed-off-by: Stefan Agner <stefan@agner.ch> --- arch/arm/boot/dts/meson8b-odroidc1.dts | 2 +- arch/arm/boot/dts/meson8m2-mxiii-plus.dts | 2 +- 2 files changed, 2 insertions(+), 2 deletions(-)