@@ -691,19 +691,8 @@ static int ufs_qcom_pwr_change_notify(struct ufs_hba *hba,
switch (status) {
case PRE_CHANGE:
- ufs_qcom_cap.tx_lanes = UFS_QCOM_LIMIT_NUM_LANES_TX;
- ufs_qcom_cap.rx_lanes = UFS_QCOM_LIMIT_NUM_LANES_RX;
- ufs_qcom_cap.hs_rx_gear = UFS_QCOM_LIMIT_HSGEAR_RX;
- ufs_qcom_cap.hs_tx_gear = UFS_QCOM_LIMIT_HSGEAR_TX;
- ufs_qcom_cap.pwm_rx_gear = UFS_QCOM_LIMIT_PWMGEAR_RX;
- ufs_qcom_cap.pwm_tx_gear = UFS_QCOM_LIMIT_PWMGEAR_TX;
- ufs_qcom_cap.rx_pwr_pwm = UFS_QCOM_LIMIT_RX_PWR_PWM;
- ufs_qcom_cap.tx_pwr_pwm = UFS_QCOM_LIMIT_TX_PWR_PWM;
- ufs_qcom_cap.rx_pwr_hs = UFS_QCOM_LIMIT_RX_PWR_HS;
- ufs_qcom_cap.tx_pwr_hs = UFS_QCOM_LIMIT_TX_PWR_HS;
+ ufshcd_init_pwr_dev_param(&ufs_qcom_cap);
ufs_qcom_cap.hs_rate = UFS_QCOM_LIMIT_HS_RATE;
- ufs_qcom_cap.desired_working_mode =
- UFS_QCOM_LIMIT_DESIRED_MODE;
if (host->hw_ver.major == 0x1) {
/*
@@ -27,18 +27,7 @@
#define SLOW 1
#define FAST 2
-#define UFS_QCOM_LIMIT_NUM_LANES_RX 2
-#define UFS_QCOM_LIMIT_NUM_LANES_TX 2
-#define UFS_QCOM_LIMIT_HSGEAR_RX UFS_HS_G3
-#define UFS_QCOM_LIMIT_HSGEAR_TX UFS_HS_G3
-#define UFS_QCOM_LIMIT_PWMGEAR_RX UFS_PWM_G4
-#define UFS_QCOM_LIMIT_PWMGEAR_TX UFS_PWM_G4
-#define UFS_QCOM_LIMIT_RX_PWR_PWM SLOW_MODE
-#define UFS_QCOM_LIMIT_TX_PWR_PWM SLOW_MODE
-#define UFS_QCOM_LIMIT_RX_PWR_HS FAST_MODE
-#define UFS_QCOM_LIMIT_TX_PWR_HS FAST_MODE
#define UFS_QCOM_LIMIT_HS_RATE PA_HS_MODE_B
-#define UFS_QCOM_LIMIT_DESIRED_MODE FAST
/* QCOM UFS host controller vendor specific registers */
enum {
Use common device parameter initialization function instead of initialziing those parameters by vendor driver itself. Signed-off-by: Stanley Chu <stanley.chu@mediatek.com> --- drivers/scsi/ufs/ufs-qcom.c | 13 +------------ drivers/scsi/ufs/ufs-qcom.h | 11 ----------- 2 files changed, 1 insertion(+), 23 deletions(-)