diff mbox series

[v3,1/4] Input: goodix - add option to disable firmware loading

Message ID 20201110090720.6650-2-andrej.valek@siemens.com
State New
Headers show
Series [v3,1/4] Input: goodix - add option to disable firmware loading | expand

Commit Message

Valek, Andrej Nov. 10, 2020, 9:07 a.m. UTC
Firmware file loadind for GT911 controller takes too much time (~60s).
There is no check that configuration is the same which is already present.
This happens always during boot, which makes touchscreen unusable.

Add there an option to prevent firmware file loading, but keep it enabled
by default.

Signed-off-by: Andrej Valek <andrej.valek@siemens.com>
---
 drivers/input/touchscreen/goodix.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/drivers/input/touchscreen/goodix.c b/drivers/input/touchscreen/goodix.c
index 02c75ea385e08..52eb2ccb0de9a 100644
--- a/drivers/input/touchscreen/goodix.c
+++ b/drivers/input/touchscreen/goodix.c
@@ -941,7 +941,9 @@  static int goodix_get_gpio_config(struct goodix_ts_data *ts)
 	default:
 		if (ts->gpiod_int && ts->gpiod_rst) {
 			ts->reset_controller_at_probe = true;
-			ts->load_cfg_from_disk = true;
+			/* Prevent cfg loading for each start */
+			ts->load_cfg_from_disk = !device_property_read_bool(dev,
+						 "goodix,do-not-load-fw");
 			ts->irq_pin_access_method = IRQ_PIN_ACCESS_GPIO;
 		}
 	}