@@ -253,6 +253,34 @@ aips1: bus@30000000 {
#size-cells = <1>;
ranges;
+ spba: bus@30000000 {
+ compatible = "fsl,spba-bus", "simple-bus";
+ #address-cells = <1>;
+ #size-cells = <1>;
+ reg = <0x30000000 0x100000>;
+ ranges;
+
+ easrc: easrc@300c0000 {
+ compatible = "fsl,imx8mn-easrc";
+ reg = <0x300c0000 0x10000>;
+ interrupts = <GIC_SPI 122 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&clk IMX8MN_CLK_ASRC_ROOT>;
+ clock-names = "mem";
+ dmas = <&sdma2 16 23 0> , <&sdma2 17 23 0>,
+ <&sdma2 18 23 0> , <&sdma2 19 23 0>,
+ <&sdma2 20 23 0> , <&sdma2 21 23 0>,
+ <&sdma2 22 23 0> , <&sdma2 23 23 0>;
+ dma-names = "ctx0_rx", "ctx0_tx",
+ "ctx1_rx", "ctx1_tx",
+ "ctx2_rx", "ctx2_tx",
+ "ctx3_rx", "ctx3_tx";
+ firmware-name = "imx/easrc/easrc-imx8mn.bin";
+ fsl,asrc-rate = <8000>;
+ fsl,asrc-format = <2>;
+ status = "disabled";
+ };
+ };
+
gpio1: gpio@30200000 {
compatible = "fsl,imx8mn-gpio", "fsl,imx35-gpio";
reg = <0x30200000 0x10000>;
The driver exists for the Enhanced Asynchronous Sample Rate Converter (EASRC) Controller, but there isn't a device tree entry for it. On the vendor kernel, they put this on a spba-bus for SDMA support. Add the node for the spba-bus with the easrc node inside. Signed-off-by: Adam Ford <aford173@gmail.com> --- V3: Change spba-bus@30000000 to spba: bus@30000000 V2: Make the DT node more in-line with the dt binding and remove vendor customizations that are not applicable.