@@ -12,6 +12,8 @@ / {
aliases {
serial0 = &blsp1_uart1;
+ sdhc1 = &sdhc_1; /* SDC1 eMMC slot */
+ sdhc2 = &sdhc_2; /* SDC2 SD card slot */
};
chosen {
@@ -161,6 +163,9 @@ pma8084_l20: l20 {
pma8084_l21: l21 {
regulator-min-microvolt = <2950000>;
regulator-max-microvolt = <2950000>;
+
+ regulator-allow-set-load;
+ regulator-system-load = <200000>;
};
pma8084_l22: l22 {
@@ -349,6 +354,24 @@ cmd-data {
};
};
+ sdhc2_pin_a: sdhc2-pin-active {
+ clk-cmd-data {
+ pins = "gpio35", "gpio36", "gpio37", "gpio38",
+ "gpio39", "gpio40";
+ function = "sdc3";
+ drive-strength = <8>;
+ bias-disable;
+ };
+ };
+
+ sdhc2_cd_pin: sdhc2-cd {
+ pins = "gpio62";
+ function = "gpio";
+
+ drive-strength = <2>;
+ bias-disable;
+ };
+
sdhc3_pin_a: sdhc3-pin-active {
clk {
pins = "sdc2_clk";
@@ -422,7 +445,7 @@ int {
};
};
- sdhci@f9824900 {
+ sdhc_1: sdhci@f9824900 {
status = "ok";
vmmc-supply = <&pma8084_l20>;
@@ -435,6 +458,25 @@ sdhci@f9824900 {
pinctrl-0 = <&sdhc1_pin_a>;
};
+ sdhc_2: sdhci@f9864900 {
+ status = "ok";
+
+ max-frequency = <100000000>;
+
+ vmmc-supply = <&pma8084_l21>;
+ vqmmc-supply = <&pma8084_l13>;
+
+ bus-width = <4>;
+
+ /* cd-gpio is intentionally disabled. If enabled, an SD card
+ * present during boot is not initialized correctly. Without
+ * cd-gpios the driver resorts to polling, so hotplug works.
+ */
+ pinctrl-names = "default";
+ pinctrl-0 = <&sdhc2_pin_a /* &sdhc2_cd_pin */>;
+ // cd-gpios = <&msmgpio 62 GPIO_ACTIVE_LOW>;
+ };
+
sdhci@f98a4900 {
status = "okay";
The Samsung Galaxy S5 (klte), has 3 SDHCI nodes used for internal storage, WiFi, external SD card slot. The external SD card slot is similar to the internal storage. Signed-off-by: Iskren Chernev <iskren.chernev@gmail.com> --- .../boot/dts/qcom-msm8974-samsung-klte.dts | 44 ++++++++++++++++++- 1 file changed, 43 insertions(+), 1 deletion(-)