diff mbox

[V3,19/19] mmc: mmci: Enforce max frequency configuration through DT

Message ID 1397132462-8005-20-git-send-email-ulf.hansson@linaro.org
State Accepted
Commit 5080a08d0f8a4b2ba3a15e5ddc5ece84a444cad8
Headers show

Commit Message

Ulf Hansson April 10, 2014, 12:21 p.m. UTC
Remove the option to provide a maximum frequency as platform data,
enforce it through DT.

Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
---
 drivers/mmc/host/mmci.c   |    5 +----
 include/linux/amba/mmci.h |    4 ----
 2 files changed, 1 insertion(+), 8 deletions(-)
diff mbox

Patch

diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c
index 04cff5e..83f5e56 100644
--- a/drivers/mmc/host/mmci.c
+++ b/drivers/mmc/host/mmci.c
@@ -1478,13 +1478,10 @@  static int mmci_probe(struct amba_device *dev,
 	 * If no maximum operating frequency is supplied, fall back to use
 	 * the module parameter, which has a (low) default value in case it
 	 * is not specified. Either value must not exceed the clock rate into
-	 * the block, of course. Also note that DT takes precedence over
-	 * platform data.
+	 * the block, of course.
 	 */
 	if (mmc->f_max)
 		mmc->f_max = min(host->mclk, mmc->f_max);
-	else if (plat->f_max)
-		mmc->f_max = min(host->mclk, plat->f_max);
 	else
 		mmc->f_max = min(host->mclk, fmax);
 	dev_dbg(mmc_dev(mmc), "clocking block at %u Hz\n", mmc->f_max);
diff --git a/include/linux/amba/mmci.h b/include/linux/amba/mmci.h
index bf339ff..8c98113 100644
--- a/include/linux/amba/mmci.h
+++ b/include/linux/amba/mmci.h
@@ -9,9 +9,6 @@ 
 /**
  * struct mmci_platform_data - platform configuration for the MMCI
  * (also known as PL180) block.
- * @f_max: the maximum operational frequency for this host in this
- * platform configuration. When this is specified it takes precedence
- * over the module parameter for the same frequency.
  * @ocr_mask: available voltages on the 4 pins from the block, this
  * is ignored if a regulator is used, see the MMC_VDD_* masks in
  * mmc/host.h
@@ -28,7 +25,6 @@ 
  * @cd_invert: true if the gpio_cd pin value is active low
  */
 struct mmci_platform_data {
-	unsigned int f_max;
 	unsigned int ocr_mask;
 	int (*ios_handler)(struct device *, struct mmc_ios *);
 	unsigned int (*status)(struct device *);