@@ -472,15 +472,10 @@ dtb_check_done:
/*
* Compute the address of the hyp vectors after relocation.
- * This requires some arithmetic since we cannot directly
- * reference __hyp_stub_vectors in a PC-relative way.
* Call __hyp_set_vectors with the new address so that we
* can HVC again after the copy.
*/
-0: adr r0, 0b
- movw r1, #:lower16:__hyp_stub_vectors - 0b
- movt r1, #:upper16:__hyp_stub_vectors - 0b
- add r0, r0, r1
+ adr_l r0, __hyp_stub_vectors
sub r0, r0, r5
add r0, r0, r10
bl __hyp_set_vectors
@@ -631,17 +626,11 @@ not_relocated: mov r0, #0
cmp r0, #HYP_MODE @ if not booted in HYP mode...
bne __enter_kernel @ boot kernel directly
- adr r12, .L__hyp_reentry_vectors_offset
- ldr r0, [r12]
- add r0, r0, r12
-
+ adr_l r0, __hyp_reentry_vectors
bl __hyp_set_vectors
__HVC(0) @ otherwise bounce to hyp mode
b . @ should never be reached
-
- .align 2
-.L__hyp_reentry_vectors_offset: .long __hyp_reentry_vectors - .
#else
b __enter_kernel
#endif
@@ -24,41 +24,38 @@ ENTRY(__boot_cpu_mode)
.text
/*
- * Save the primary CPU boot mode. Requires 3 scratch registers.
+ * Save the primary CPU boot mode. Requires 2 scratch registers.
*/
- .macro store_primary_cpu_mode reg1, reg2, reg3
+ .macro store_primary_cpu_mode reg1, reg2
mrs \reg1, cpsr
and \reg1, \reg1, #MODE_MASK
- adr \reg2, .L__boot_cpu_mode_offset
- ldr \reg3, [\reg2]
- str \reg1, [\reg2, \reg3]
+ str_l \reg1, __boot_cpu_mode, \reg2
.endm
/*
* Compare the current mode with the one saved on the primary CPU.
* If they don't match, record that fact. The Z bit indicates
* if there's a match or not.
- * Requires 3 additionnal scratch registers.
+ * Requires 2 additional scratch registers.
*/
- .macro compare_cpu_mode_with_primary mode, reg1, reg2, reg3
- adr \reg2, .L__boot_cpu_mode_offset
- ldr \reg3, [\reg2]
- ldr \reg1, [\reg2, \reg3]
+ .macro compare_cpu_mode_with_primary mode, reg1, reg2
+ adr_l \reg2, __boot_cpu_mode
+ ldr \reg1, [\reg2]
cmp \mode, \reg1 @ matches primary CPU boot mode?
orrne \reg1, \reg1, #BOOT_CPU_MODE_MISMATCH
- strne \reg1, [\reg2, \reg3] @ record what happened and give up
+ strne \reg1, [\reg2] @ record what happened and give up
.endm
#else /* ZIMAGE */
- .macro store_primary_cpu_mode reg1:req, reg2:req, reg3:req
+ .macro store_primary_cpu_mode reg1:req, reg2:req
.endm
/*
* The zImage loader only runs on one CPU, so we don't bother with mult-CPU
* consistency checking:
*/
- .macro compare_cpu_mode_with_primary mode, reg1, reg2, reg3
+ .macro compare_cpu_mode_with_primary mode, reg1, reg2
cmp \mode, \mode
.endm
@@ -73,7 +70,7 @@ ENTRY(__boot_cpu_mode)
*/
@ Call this from the primary CPU
ENTRY(__hyp_stub_install)
- store_primary_cpu_mode r4, r5, r6
+ store_primary_cpu_mode r4, r5
ENDPROC(__hyp_stub_install)
@ fall through...
@@ -87,7 +84,7 @@ ENTRY(__hyp_stub_install_secondary)
* If the secondary has booted with a different mode, give up
* immediately.
*/
- compare_cpu_mode_with_primary r4, r5, r6, r7
+ compare_cpu_mode_with_primary r4, r5, r6
retne lr
/*
Replace the open coded calculations of the actual physical address of the KVM stub vector table with a single adr_l invocation. Signed-off-by: Ard Biesheuvel <ardb@kernel.org> --- arch/arm/boot/compressed/head.S | 15 ++--------- arch/arm/kernel/hyp-stub.S | 27 +++++++++----------- 2 files changed, 14 insertions(+), 28 deletions(-)