@@ -3038,60 +3038,6 @@
*/
ti,no-idle;
- mac: ethernet@0 {
- compatible = "ti,dra7-cpsw","ti,cpsw";
- clocks = <&gmac_main_clk>, <&gmac_clkctrl DRA7_GMAC_GMAC_CLKCTRL 25>;
- clock-names = "fck", "cpts";
- cpdma_channels = <8>;
- ale_entries = <1024>;
- bd_ram_size = <0x2000>;
- mac_control = <0x20>;
- slaves = <2>;
- active_slave = <0>;
- cpts_clock_mult = <0x784CFE14>;
- cpts_clock_shift = <29>;
- reg = <0x0 0x1000
- 0x1200 0x2e00>;
- #address-cells = <1>;
- #size-cells = <1>;
-
- /*
- * rx_thresh_pend
- * rx_pend
- * tx_pend
- * misc_pend
- */
- interrupts = <GIC_SPI 334 IRQ_TYPE_LEVEL_HIGH>,
- <GIC_SPI 335 IRQ_TYPE_LEVEL_HIGH>,
- <GIC_SPI 336 IRQ_TYPE_LEVEL_HIGH>,
- <GIC_SPI 337 IRQ_TYPE_LEVEL_HIGH>;
- ranges = <0 0 0x4000>;
- syscon = <&scm_conf>;
- status = "disabled";
-
- davinci_mdio: mdio@1000 {
- compatible = "ti,cpsw-mdio","ti,davinci_mdio";
- clocks = <&gmac_main_clk>;
- clock-names = "fck";
- #address-cells = <1>;
- #size-cells = <0>;
- bus_freq = <1000000>;
- reg = <0x1000 0x100>;
- };
-
- cpsw_emac0: slave@200 {
- /* Filled in by U-Boot */
- mac-address = [ 00 00 00 00 00 00 ];
- phys = <&phy_gmii_sel 1>;
- };
-
- cpsw_emac1: slave@300 {
- /* Filled in by U-Boot */
- mac-address = [ 00 00 00 00 00 00 ];
- phys = <&phy_gmii_sel 2>;
- };
- };
-
mac_sw: switch@0 {
compatible = "ti,dra7-cpsw-switch","ti,cpsw-switch";
reg = <0x0 0x4000>;
@@ -37,8 +37,8 @@
serial7 = &uart8;
serial8 = &uart9;
serial9 = &uart10;
- ethernet0 = &cpsw_emac0;
- ethernet1 = &cpsw_emac1;
+ ethernet0 = &cpsw_port1;
+ ethernet1 = &cpsw_port2;
d_can0 = &dcan1;
d_can1 = &dcan2;
spi0 = &qspi;
All dra7/am57 boards converted to use new driver, so drop legacy cpsw dt node. Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com> --- arch/arm/boot/dts/dra7-l4.dtsi | 54 ---------------------------------- arch/arm/boot/dts/dra7.dtsi | 4 +-- 2 files changed, 2 insertions(+), 56 deletions(-) -- 2.17.1