diff mbox series

armv8: ls1012a: RGMII ports require internal delay

Message ID 1591699908-21744-1-git-send-email-chaitanya.sakinam@nxp.com
State Accepted
Commit cb1de6067aae8bd3dc8161db0d92f19a4e60942a
Headers show
Series armv8: ls1012a: RGMII ports require internal delay | expand

Commit Message

Chaitanya Sakinam June 9, 2020, 10:51 a.m. UTC 
The correct setting for the RGMII ports on LS1012ARDB is to
enable delay on both Rx and Tx so the interface mode used should
be PHY_INTERFACE_MODE_RGMII_ID

Signed-off-by: Chaitanya Sakinam <chaitanya.sakinam at nxp.com>
Signed-off-by: Anji J <anji.jagarlmudi at nxp.com>
---
 board/freescale/ls1012ardb/eth.c | 2 +-
 drivers/net/pfe_eth/pfe_eth.c    | 2 +-
 2 files changed, 2 insertions(+), 2 deletions(-)
diff mbox series

Patch

diff --git a/board/freescale/ls1012ardb/eth.c b/board/freescale/ls1012ardb/eth.c
index 5edcfcf..ca15349 100644
--- a/board/freescale/ls1012ardb/eth.c
+++ b/board/freescale/ls1012ardb/eth.c
@@ -112,7 +112,7 @@  int pfe_eth_board_init(struct udevice *dev)
 			/* MAC2 */
 			pfe_set_phy_address_mode(priv->gemac_port,
 						 CONFIG_PFE_EMAC2_PHY_ADDR,
-						 PHY_INTERFACE_MODE_RGMII_TXID);
+						 PHY_INTERFACE_MODE_RGMII_ID);
 		}
 		break;
 	case 0x2208:
diff --git a/drivers/net/pfe_eth/pfe_eth.c b/drivers/net/pfe_eth/pfe_eth.c
index 1b5d11e..6e22041 100644
--- a/drivers/net/pfe_eth/pfe_eth.c
+++ b/drivers/net/pfe_eth/pfe_eth.c
@@ -31,7 +31,7 @@  struct gemac_s gem_info[] = {
 
 		/* phy iface */
 		.phy_address = CONFIG_PFE_EMAC2_PHY_ADDR,
-		.phy_mode = PHY_INTERFACE_MODE_RGMII_TXID,
+		.phy_mode = PHY_INTERFACE_MODE_RGMII_ID,
 	},
 };