@@ -121,15 +121,6 @@ config NAND_DENALI_DT
Enable the driver for NAND flash on platforms using a Denali NAND
controller as a DT device.
-config NAND_DENALI_SPARE_AREA_SKIP_BYTES
- int "Number of bytes skipped in OOB area"
- depends on NAND_DENALI
- range 0 63
- help
- This option specifies the number of bytes to skip from the beginning
- of OOB area before last ECC sector data starts. This is potentially
- used to preserve the bad block marker in the OOB area.
-
config NAND_LPC32XX_SLC
bool "Support LPC32XX_SLC controller"
help
@@ -404,6 +395,15 @@ config SPL_NAND_DENALI
This is a small implementation of the Denali NAND controller
for use on SPL.
+config NAND_DENALI_SPARE_AREA_SKIP_BYTES
+ int "Number of bytes skipped in OOB area"
+ depends on SPL_NAND_DENALI
+ range 0 63
+ help
+ This option specifies the number of bytes to skip from the beginning
+ of OOB area before last ECC sector data starts. This is potentially
+ used to preserve the bad block marker in the OOB area.
+
config SPL_NAND_SIMPLE
bool "Use simple SPL NAND driver"
depends on !SPL_NAND_AM33XX_BCH
This CONFIG option is only used in denali_spl.c Move it close to SPL_NAND_DENALI, and make it depend on SPL_NAND_DENALI. Signed-off-by: Masahiro Yamada <yamada.masahiro at socionext.com> --- drivers/mtd/nand/raw/Kconfig | 18 +++++++++--------- 1 file changed, 9 insertions(+), 9 deletions(-)