@@ -75,7 +75,8 @@ enum {
/* Vendor2 MMD registers */
MV_V2_PORT_CTRL = 0xf001,
- MV_V2_PORT_CTRL_PWRDOWN = 0x0800,
+ MV_V2_PORT_CTRL_SWRST = BIT(15),
+ MV_V2_PORT_CTRL_PWRDOWN = BIT(11),
MV_V2_TEMP_CTRL = 0xf08a,
MV_V2_TEMP_CTRL_MASK = 0xc000,
MV_V2_TEMP_CTRL_SAMPLE = 0x0000,
@@ -239,8 +240,19 @@ static int mv3310_power_down(struct phy_device *phydev)
static int mv3310_power_up(struct phy_device *phydev)
{
- return phy_clear_bits_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL,
- MV_V2_PORT_CTRL_PWRDOWN);
+ struct mv3310_priv *priv = dev_get_drvdata(&phydev->mdio.dev);
+ int ret;
+
+ ret = phy_clear_bits_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL,
+ MV_V2_PORT_CTRL_PWRDOWN);
+
+ if (priv->firmware_ver < 0x00030000)
+ return ret;
+
+ ret = phy_set_bits_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL,
+ MV_V2_PORT_CTRL_SWRST);
+
+ return ret;
}
static int mv3310_reset(struct phy_device *phydev, u32 unit)
Soft-reset the PHY when coming out of low power mode, which seems to be necessary with firmware versions 0.3.3.0 and 0.3.10.0. This depends on ("net: marvell10g: report firmware version") Fixes: c9cc1c815d36 ("net: phy: marvell10g: place in powersave mode at probe") Reported-by: Matteo Croce <mcroce@redhat.com> Tested-by: Matteo Croce <mcroce@redhat.com> Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk> --- drivers/net/phy/marvell10g.c | 18 +++++++++++++++--- 1 file changed, 15 insertions(+), 3 deletions(-)