@@ -66,6 +66,7 @@
/* STRAP_STS1 bits */
#define DP83869_STRAP_STS1_RESERVED BIT(11)
+#define DP83869_STRAP_MIRROR_ENABLED BIT(12)
/* PHYCTRL bits */
#define DP83869_RX_FIFO_SHIFT 12
@@ -191,10 +192,18 @@ static int dp83869_of_init(struct phy_device *phydev)
else if (of_property_read_bool(of_node, "ti,min-output-impedance"))
dp83869->io_impedance = DP83869_IO_MUX_CFG_IO_IMPEDANCE_MIN;
- if (of_property_read_bool(of_node, "enet-phy-lane-swap"))
+ if (of_property_read_bool(of_node, "enet-phy-lane-swap")) {
dp83869->port_mirroring = DP83869_PORT_MIRRORING_EN;
- else
- dp83869->port_mirroring = DP83869_PORT_MIRRORING_DIS;
+ } else {
+ /* If the lane swap is not in the DT then check the straps */
+ ret = phy_read_mmd(phydev, DP83869_DEVADDR, DP83869_STRAP_STS1);
+ if (ret < 0)
+ return ret;
+ if (ret & DP83869_STRAP_MIRROR_ENABLED)
+ dp83869->port_mirroring = DP83869_PORT_MIRRORING_EN;
+ else
+ dp83869->port_mirroring = DP83869_PORT_MIRRORING_DIS;
+ }
if (of_property_read_u32(of_node, "rx-fifo-depth",
&dp83869->rx_fifo_depth))
The device tree may not have the property set for port mirroring because the hardware may have it strapped. If the property is not in the DT then check the straps and set the port mirroring bit appropriately. Signed-off-by: Dan Murphy <dmurphy@ti.com> --- drivers/net/phy/dp83869.c | 15 ++++++++++++--- 1 file changed, 12 insertions(+), 3 deletions(-)