@@ -840,7 +840,7 @@ static void phy_error(struct phy_device *phydev)
* phy_disable_interrupts - Disable the PHY interrupts from the PHY side
* @phydev: target phy_device struct
*/
-static int phy_disable_interrupts(struct phy_device *phydev)
+int phy_disable_interrupts(struct phy_device *phydev)
{
int err;
@@ -1416,6 +1416,7 @@ int phy_ethtool_ksettings_set(struct phy_device *phydev,
int phy_mii_ioctl(struct phy_device *phydev, struct ifreq *ifr, int cmd);
int phy_do_ioctl(struct net_device *dev, struct ifreq *ifr, int cmd);
int phy_do_ioctl_running(struct net_device *dev, struct ifreq *ifr, int cmd);
+int phy_disable_interrupts(struct phy_device *phydev);
void phy_request_interrupt(struct phy_device *phydev);
void phy_free_interrupt(struct phy_device *phydev);
void phy_print_status(struct phy_device *phydev);
We face an issue with rtl8211f, a pin is shared between INTB and PMEB, and the PHY Register Accessible Interrupt is enabled by default, so the INTB/PMEB pin is always active in polling mode case. As Heiner pointed out "I was thinking about calling phy_disable_interrupts() in phy_init_hw(), to have a defined init state as we don't know in which state the PHY is if the PHY driver is loaded. We shouldn't assume that it's the chip power-on defaults, BIOS or boot loader could have changed this. Or in case of dual-boot systems the other OS could leave the PHY in whatever state." Make phy_disable_interrupts() non-static so that it could be used in phy_init_hw() to have a defined init state. Suggested-by: Heiner Kallweit <hkallweit1@gmail.com> Signed-off-by: Jisheng Zhang <Jisheng.Zhang@synaptics.com> --- drivers/net/phy/phy.c | 2 +- include/linux/phy.h | 1 + 2 files changed, 2 insertions(+), 1 deletion(-)