@@ -90,6 +90,23 @@ static int stfsm_n25q_prepare_en_32bit_addr_seq(struct stfsm_seq *seq)
return 0;
}
+static struct stfsm_seq stfsm_seq_wrvcr = {
+ .seq_opc[0] = (SEQ_OPC_PADS_1 | SEQ_OPC_CYCLES(8) |
+ SEQ_OPC_OPCODE(FLASH_CMD_WREN) | SEQ_OPC_CSDEASSERT),
+ .seq_opc[1] = (SEQ_OPC_PADS_1 | SEQ_OPC_CYCLES(8) |
+ SEQ_OPC_OPCODE(FLASH_CMD_WRVCR)),
+ .seq = {
+ STFSM_INST_CMD1,
+ STFSM_INST_CMD2,
+ STFSM_INST_STA_WR1,
+ STFSM_INST_STOP,
+ },
+ .seq_cfg = (SEQ_CFG_PADS_1 |
+ SEQ_CFG_READNOTWRITE |
+ SEQ_CFG_CSDEASSERT |
+ SEQ_CFG_STARTSEQ),
+};
+
static inline int stfsm_is_idle(struct stfsm *fsm)
{
return readl(fsm->base + SPI_FAST_SEQ_STA) & 0x10;
@@ -147,6 +164,21 @@ static int stfsm_enter_32bit_addr(struct stfsm *fsm, int enter)
return 0;
}
+static int stfsm_wrvcr(struct stfsm *fsm, uint8_t data)
+{
+ struct stfsm_seq *seq = &stfsm_seq_wrvcr;
+
+ dev_dbg(fsm->dev, "writing VCR 0x%02x\n", data);
+
+ seq->status = (STA_DATA_BYTE1(data) | STA_PADS_1 | STA_CSDEASSERT);
+
+ stfsm_load_seq(fsm, seq);
+
+ stfsm_wait_seq(fsm);
+
+ return 0;
+}
+
/*
* SoC reset on 'boot-from-spi' systems
*
The FSM Serial Flash Controller is driven by issuing a standard set of register writes we call a message sequence. This patch supplies a method to prepare the message sequence responsible for updating a chip's VCR. Signed-off-by: Lee Jones <lee.jones@linaro.org> --- drivers/mtd/devices/st_spi_fsm.c | 32 ++++++++++++++++++++++++++++++++ 1 file changed, 32 insertions(+)