diff mbox series

[1/2] pinctrl: sprd: Use the correct pin output configuration

Message ID 8a6f91b49c17beb218e46b23084f59a7c7260f86.1585124562.git.baolin.wang7@gmail.com
State New
Headers show
Series [1/2] pinctrl: sprd: Use the correct pin output configuration | expand

Commit Message

Baolin Wang March 25, 2020, 8:25 a.m. UTC 
From: Linhua Xu <linhua.xu@unisoc.com>

The Spreadtrum pin controller did not supply registers to set high level
or low level for output mode, instead we should let the pin controller
current configuration drive values on the line. So we should use the
PIN_CONFIG_OUTPUT_ENABLE configuration to enable or disable the output
mode.

[Baolin Wang changes the commit message]
Fixes: 41d32cfce1ae ("pinctrl: sprd: Add Spreadtrum pin control driver")
Signed-off-by: Linhua Xu <linhua.xu@unisoc.com>
Signed-off-by: Baolin Wang <baolin.wang7@gmail.com>
---
 drivers/pinctrl/sprd/pinctrl-sprd.c | 10 +++++++---
 1 file changed, 7 insertions(+), 3 deletions(-)
diff mbox series

Patch

diff --git a/drivers/pinctrl/sprd/pinctrl-sprd.c b/drivers/pinctrl/sprd/pinctrl-sprd.c
index ea04bac..8e39610 100644
--- a/drivers/pinctrl/sprd/pinctrl-sprd.c
+++ b/drivers/pinctrl/sprd/pinctrl-sprd.c
@@ -464,7 +464,7 @@  static int sprd_pinconf_get(struct pinctrl_dev *pctldev, unsigned int pin_id,
 		case PIN_CONFIG_INPUT_ENABLE:
 			arg = (reg >> SLEEP_INPUT_SHIFT) & SLEEP_INPUT_MASK;
 			break;
-		case PIN_CONFIG_OUTPUT:
+		case PIN_CONFIG_OUTPUT_ENABLE:
 			arg = reg & SLEEP_OUTPUT_MASK;
 			break;
 		case PIN_CONFIG_DRIVE_STRENGTH:
@@ -635,9 +635,13 @@  static int sprd_pinconf_set(struct pinctrl_dev *pctldev, unsigned int pin_id,
 					shift = SLEEP_INPUT_SHIFT;
 				}
 				break;
-			case PIN_CONFIG_OUTPUT:
+			case PIN_CONFIG_OUTPUT_ENABLE:
 				if (is_sleep_config == true) {
-					val |= SLEEP_OUTPUT;
+					if (arg > 0)
+						val |= SLEEP_OUTPUT;
+					else
+						val &= ~SLEEP_OUTPUT;
+
 					mask = SLEEP_OUTPUT_MASK;
 					shift = SLEEP_OUTPUT_SHIFT;
 				}