@@ -29,6 +29,26 @@
regulator-max-microvolt = <5000000>;
};
+ ir-receiver {
+ compatible = "gpio-ir-receiver";
+ gpios = <&gpio0 RK_PA6 GPIO_ACTIVE_LOW>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&ir_rx>;
+ };
+
+ leds {
+ compatible = "gpio-leds";
+ pinctrl-names = "default";
+ pinctrl-0 = <&power_led_gpio>;
+
+ power-led {
+ label = "blue:power";
+ gpios = <&gpio4 RK_PC2 GPIO_ACTIVE_HIGH>;
+ default-state = "on";
+ linux,default-trigger = "none";
+ };
+ };
+
vcc_sys: vcc-sys {
compatible = "regulator-fixed";
regulator-name = "vcc_sys";
@@ -483,6 +503,18 @@
};
};
+ ir {
+ ir_rx: ir-rx {
+ rockchip,pins = <0 RK_PA6 1 &pcfg_pull_none>;
+ };
+ };
+
+ leds {
+ power_led_gpio: power-led-gpio {
+ rockchip,pins = <4 RK_PC2 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
pmic {
pmic_int_l: pmic-int-l {
rockchip,pins =
@@ -539,10 +572,6 @@
};
};
-&pwm0 {
- status = "okay";
-};
-
&pwm2 {
status = "okay";
pinctrl-0 = <&pwm2_pin_pull_down>;
- Add Hugsun X99 IR receiver and power led - Remove pwm0 node as it interferes with pwer LED gpio Also, it's not used in factory firmware Tested with Libreelec kernel v5.6 Signed-off-by: Vivek Unune <npcomplete13@gmail.com> --- .../boot/dts/rockchip/rk3399-hugsun-x99.dts | 37 +++++++++++++++++-- 1 file changed, 33 insertions(+), 4 deletions(-)