@@ -1,7 +1,7 @@
TI LP87565 PMIC MFD driver
Required properties:
- - compatible: "ti,lp87565", "ti,lp87565-q1"
+ - compatible: one of "ti,lp87565", "ti,lp87565-q1", "ti,lp87561-q1"
- reg: I2C slave address.
- gpio-controller: Marks the device node as a GPIO Controller.
- #gpio-cells: Should be two. The first cell is the pin number and
@@ -10,7 +10,8 @@ Required properties:
- xxx-in-supply: Phandle to parent supply node of each regulator
populated under regulators node. xxx should match
the supply_name populated in driver.
-Example:
+
+Example for the TI LP87565-Q1 PMIC (dual 2-phase output configuration):
lp87565_pmic: pmic@60 {
compatible = "ti,lp87565-q1";
@@ -42,21 +43,7 @@ lp87565_pmic: pmic@60 {
};
};
-TI LP87561 PMIC:
-
-This is a single output 4-phase regulator configuration
-
-Required properties:
- - compatible: "ti,lp87561-q1"
- - reg: I2C slave address.
- - gpio-controller: Marks the device node as a GPIO Controller.
- - #gpio-cells: Should be two. The first cell is the pin number and
- the second cell is used to specify flags.
- See ../gpio/gpio.txt for more information.
- - xxx-in-supply: Phandle to parent supply node of each regulator
- populated under regulators node. xxx should match
- the supply_name populated in driver.
-Example:
+Example for the TI LP87561 PMIC (single 4-phase output configuration):
lp87561_pmic: pmic@62 {
compatible = "ti,lp87561-q1";
The "Required properties:" section is copied verbatim for each of the two supported chips. In preparation to add a new chip variant make it a common section and keep the two examples to differentiate between the two chips. Signed-off-by: Luca Ceresoli <luca@lucaceresoli.net> --- .../devicetree/bindings/mfd/lp87565.txt | 21 ++++--------------- 1 file changed, 4 insertions(+), 17 deletions(-)