diff mbox

[1/5] hw/pl181: Implement GPIO output pins for card status

Message ID 1298321873-17064-2-git-send-email-peter.maydell@linaro.org
State Accepted
Commit c31a4724e25ef867acda0eafc7ddb3999e4bb204
Headers show

Commit Message

Peter Maydell Feb. 21, 2011, 8:57 p.m. UTC 
Add two GPIO output pins to the PL181 model to indicate the card
present and readonly status information. On ARM boards these usually
are reflected in a system register.

Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
---
 hw/pl181.c |    6 ++++++
 1 files changed, 6 insertions(+), 0 deletions(-)
diff mbox

Patch

diff --git a/hw/pl181.c b/hw/pl181.c
index 36d9d02..6bc79f5 100644
--- a/hw/pl181.c
+++ b/hw/pl181.c
@@ -47,6 +47,8 @@  typedef struct {
     int linux_hack;
     uint32_t fifo[PL181_FIFO_LEN];
     qemu_irq irq[2];
+    /* GPIO outputs for 'card is readonly' and 'card inserted' */
+    qemu_irq cardstatus[2];
 } pl181_state;
 
 #define PL181_CMD_INDEX     0x3f
@@ -444,6 +446,9 @@  static void pl181_reset(void *opaque)
     s->linux_hack = 0;
     s->mask[0] = 0;
     s->mask[1] = 0;
+
+    /* We can assume our GPIO outputs have been wired up now */
+    sd_set_cb(s->card, s->cardstatus[0], s->cardstatus[1]);
 }
 
 static int pl181_init(SysBusDevice *dev)
@@ -457,6 +462,7 @@  static int pl181_init(SysBusDevice *dev)
     sysbus_init_mmio(dev, 0x1000, iomemtype);
     sysbus_init_irq(dev, &s->irq[0]);
     sysbus_init_irq(dev, &s->irq[1]);
+    qdev_init_gpio_out(&s->busdev.qdev, s->cardstatus, 2);
     dinfo = drive_get_next(IF_SD);
     s->card = sd_init(dinfo ? dinfo->bdrv : NULL, 0);
     qemu_register_reset(pl181_reset, s);