@@ -8,8 +8,6 @@ Required properties:
- ti,tx-internal-delay - RGMII Transmit Clock Delay - see dt-bindings/net/ti-dp83867.h
for applicable values. Required only if interface type is
PHY_INTERFACE_MODE_RGMII_ID or PHY_INTERFACE_MODE_RGMII_TXID
- - ti,fifo-depth - Transmitt FIFO depth- see dt-bindings/net/ti-dp83867.h
- for applicable values
Note: If the interface type is PHY_INTERFACE_MODE_RGMII the TX/RX clock delays
will be left at their default values, as set by the PHY's pin strapping.
@@ -38,6 +36,14 @@ Optional property:
be disabled by this property. When omitted, the
PHY's default will be left as is.
+ - ti,fifo-depth - Transmitt FIFO depth- see dt-bindings/net/ti-dp83867.h
+ for applicable values (deprecated)
+
+ -tx-fifo-depth - As defined in the ethernet-controller.yaml. Values for
+ the depth can be found in dt-bindings/net/ti-dp83867.h
+ -rx-fifo-depth - As defined in the ethernet-controller.yaml. Values for
+ the depth can be found in dt-bindings/net/ti-dp83867.h
+
Note: ti,min-output-impedance and ti,max-output-impedance are mutually
exclusive. When both properties are present ti,max-output-impedance
takes precedence.
@@ -51,7 +57,7 @@ Example:
reg = <0>;
ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_25_NS>;
ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_75_NS>;
- ti,fifo-depth = <DP83867_PHYCR_FIFO_DEPTH_4_B_NIB>;
+ tx-fifo-depth = <DP83867_PHYCR_FIFO_DEPTH_4_B_NIB>;
};
Datasheet can be found:
Convert the ti,fifo-depth from a TI specific property to the common tx-fifo-depth property. Also add support for the rx-fifo-depth. These are optional properties for this device and if these are not available then the fifo depths are set to device default values. Signed-off-by: Dan Murphy <dmurphy@ti.com> Reported-by: Adrian Bunk <bunk@kernel.org> CC: Rob Herring <robh@kernel.org> --- Documentation/devicetree/bindings/net/ti,dp83867.txt | 12 +++++++++--- 1 file changed, 9 insertions(+), 3 deletions(-) -- 2.23.0