diff mbox series

[2/2] spi: sprd: adi: Set BIT_WDG_NEW bit when rebooting

Message ID 5655318a7252c9ea518c2f7950a61228ab8f42bf.1572257085.git.baolin.wang@linaro.org
State New
Headers show
Series None | expand

Commit Message

(Exiting) Baolin Wang Oct. 28, 2019, 10:10 a.m. UTC 
From: Lingling Xu <ling_ling.xu@unisoc.com>


When rebooting system, the PMIC watchdog time loading may not be loaded
correctly when another system is feeding the PMIC watchdog, since we did
not check the watchdog busy status before loading time values.

Thus we should set the BIT_WDG_NEW bit before loading time values, that
can support multiple loads without checking busy status to make sure the
time values can be loaded successfully to avoid this potential issue.

Signed-off-by: Lingling Xu <ling_ling.xu@unisoc.com>

Signed-off-by: Baolin Wang <baolin.wang@linaro.org>

---
 drivers/spi/spi-sprd-adi.c |    5 +++++
 1 file changed, 5 insertions(+)

-- 
1.7.9.5
diff mbox series

Patch

diff --git a/drivers/spi/spi-sprd-adi.c b/drivers/spi/spi-sprd-adi.c
index 9613cfe..87dadb6 100644
--- a/drivers/spi/spi-sprd-adi.c
+++ b/drivers/spi/spi-sprd-adi.c
@@ -77,6 +77,7 @@ 
 
 /* Bits definitions for register REG_WDG_CTRL */
 #define BIT_WDG_RUN			BIT(1)
+#define BIT_WDG_NEW			BIT(2)
 #define BIT_WDG_RST			BIT(3)
 
 /* Registers definitions for PMIC */
@@ -383,6 +384,10 @@  static int sprd_adi_restart_handler(struct notifier_block *this,
 	/* Unlock the watchdog */
 	sprd_adi_write(sadi, sadi->slave_pbase + REG_WDG_LOCK, WDG_UNLOCK_KEY);
 
+	sprd_adi_read(sadi, sadi->slave_pbase + REG_WDG_CTRL, &val);
+	val |= BIT_WDG_NEW;
+	sprd_adi_write(sadi, sadi->slave_pbase + REG_WDG_CTRL, val);
+
 	/* Load the watchdog timeout value, 50ms is always enough. */
 	sprd_adi_write(sadi, sadi->slave_pbase + REG_WDG_LOAD_LOW,
 		       WDG_LOAD_VAL & WDG_LOAD_MASK);