@@ -75,16 +75,44 @@ config IOMMU_DEBUGFS
debug/iommu directory, and then populate a subdirectory with
entries as required.
-config IOMMU_DEFAULT_PASSTHROUGH
- bool "IOMMU passthrough by default"
+choice
+ prompt "IOMMU default DMA mode"
depends on IOMMU_API
- help
- Enable passthrough by default, removing the need to pass in
- iommu.passthrough=on or iommu=pt through command line. If this
- is enabled, you can still disable with iommu.passthrough=off
- or iommu=nopt depending on the architecture.
+ default IOMMU_DEFAULT_STRICT
+ help
+ This option allows an IOMMU DMA mode to be chosen at build time, to
+ override the default DMA mode of each ARCH, removing the need to
+ pass in kernel parameters through command line. You can still use
+ ARCH specific boot options to override this option again.
- If unsure, say N here.
+ If unsure, keep the default.
+
+config IOMMU_DEFAULT_PASSTHROUGH
+ bool "passthrough"
+ help
+ In this mode, the DMA access through IOMMU without any addresses
+ translation. That means, the wrong or illegal DMA access can not
+ be caught, no error information will be reported.
+
+config IOMMU_DEFAULT_LAZY
+ bool "lazy"
+ help
+ Support lazy mode, where for every IOMMU DMA unmap operation, the
+ flush operation of IOTLB and the free operation of IOVA are deferred.
+ They are only guaranteed to be done before the related IOVA will be
+ reused.
+
+config IOMMU_DEFAULT_STRICT
+ bool "strict"
+ help
+ For every IOMMU DMA unmap operation, the flush operation of IOTLB and
+ the free operation of IOVA are guaranteed to be done in the unmap
+ function.
+
+ This mode is safer than the two above, but it maybe slower in some
+ high performace scenarios.
+
+endchoice
config OF_IOMMU
def_bool y
@@ -31,7 +31,8 @@
#else
static unsigned int iommu_def_domain_type = IOMMU_DOMAIN_DMA;
#endif
-static bool iommu_dma_strict __read_mostly = true;
+static bool iommu_dma_strict __read_mostly =
+ IS_ENABLED(CONFIG_IOMMU_DEFAULT_STRICT);
struct iommu_group {
struct kobject kobj;
First, add build option IOMMU_DEFAULT_{LAZY|STRICT}, so that we have the opportunity to set {lazy|strict} mode as default at build time. Then put the three config options in an choice, make people can only choose one of the three at a time. Signed-off-by: Zhen Lei <thunder.leizhen@huawei.com> --- drivers/iommu/Kconfig | 44 ++++++++++++++++++++++++++++++++++++-------- drivers/iommu/iommu.c | 3 ++- 2 files changed, 38 insertions(+), 9 deletions(-) -- 1.8.3