@@ -1578,6 +1578,22 @@ static void rt5651_disable_micbias1_for_ovcd(struct snd_soc_component *component
snd_soc_dapm_mutex_unlock(dapm);
}
+static void rt5651_clear_micbias1_ovcd(struct snd_soc_component *component)
+{
+ snd_soc_component_update_bits(component, RT5651_IRQ_CTRL2,
+ RT5651_MB1_OC_CLR, 0);
+}
+
+static bool rt5651_micbias1_ovcd(struct snd_soc_component *component)
+{
+ int val;
+
+ val = snd_soc_component_read32(component, RT5651_IRQ_CTRL2);
+ dev_dbg(component->dev, "irq ctrl2 %#04x\n", val);
+
+ return (val & RT5651_MB1_OC_CLR);
+}
+
static irqreturn_t rt5651_irq(int irq, void *data)
{
struct rt5651_priv *rt5651 = data;
@@ -1646,6 +1662,18 @@ static int rt5651_set_jack(struct snd_soc_component *component,
RT5651_PWR_MB_PU |
RT5651_PWR_CLK12M_PU);
+ /*
+ * The over-current-detect is only reliable in detecting the absence
+ * of over-current, when the mic-contact in the jack is short-circuited,
+ * the hardware periodically retries if it can apply the bias-current
+ * leading to the ovcd status flip-flopping 1-0-1 with it being 0 about
+ * 10% of the time, as we poll the ovcd status bit we might hit that
+ * 10%, so we enable sticky mode and when checking OVCD we clear the
+ * status, msleep() a bit and then check to get a reliable reading.
+ */
+ snd_soc_component_update_bits(component, RT5651_IRQ_CTRL2,
+ RT5651_MB1_OC_STKY_MASK, RT5651_MB1_OC_STKY_EN);
+
rt5651->hp_jack = hp_jack;
ret = devm_request_threaded_irq(component->dev, rt5651->irq, NULL,
@@ -1878,13 +1906,12 @@ static int rt5651_jack_detect(struct snd_soc_component *component, int jack_inse
if (jack_insert) {
rt5651_enable_micbias1_for_ovcd(component);
+ rt5651_clear_micbias1_ovcd(component);
msleep(100);
- if (snd_soc_component_read32(component, RT5651_IRQ_CTRL2) & RT5651_MB1_OC_CLR)
+ if (rt5651_micbias1_ovcd(component))
jack_type = SND_JACK_HEADPHONE;
else
jack_type = SND_JACK_HEADSET;
- snd_soc_component_update_bits(component, RT5651_IRQ_CTRL2,
- RT5651_MB1_OC_CLR, 0);
rt5651_disable_micbias1_for_ovcd(component);
} else { /* jack out */
jack_type = 0;