new file mode 100644
@@ -0,0 +1,98 @@
+Cadence MIPI-CSI2 TX controller
+===============================
+
+The Cadence MIPI-CSI2 TX controller is a CSI-2 bridge supporting up to
+4 CSI lanes in output, and up to 4 different pixel streams in input.
+
+Required properties:
+ - compatible: must be set to "cdns,csi2tx"
+ - reg: base address and size of the memory mapped region
+ - clocks: phandles to the clocks driving the controller
+ - clock-names: must contain:
+ * esc_clk: escape mode clock
+ * p_clk: register bank clock
+ * pixel_if[0-3]_clk: pixel stream output clock, one for each stream
+ implemented in hardware, between 0 and 3
+
+Optional properties
+ - phys: phandle to the D-PHY. If it is set, phy-names need to be set
+ - phy-names: must contain dphy
+
+Required subnodes:
+ - ports: A ports node with one port child node per device input and output
+ port, in accordance with the video interface bindings defined in
+ Documentation/devicetree/bindings/media/video-interfaces.txt. The
+ port nodes numbered as follows.
+
+ Port Description
+ -----------------------------
+ 0 CSI-2 output
+ 1 Stream 0 input
+ 2 Stream 1 input
+ 3 Stream 2 input
+ 4 Stream 3 input
+
+ The stream input port nodes are optional if they are not
+ connected to anything at the hardware level or implemented
+ in the design. Since there is only one endpoint per port,
+ the endpoints are not numbered.
+
+Example:
+
+csi2tx: csi-bridge@0d0e1000 {
+ compatible = "cdns,csi2tx";
+ reg = <0x0d0e1000 0x1000>;
+ clocks = <&byteclock>, <&byteclock>,
+ <&coreclock>, <&coreclock>,
+ <&coreclock>, <&coreclock>;
+ clock-names = "p_clk", "esc_clk",
+ "pixel_if0_clk", "pixel_if1_clk",
+ "pixel_if2_clk", "pixel_if3_clk";
+
+ ports {
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ port@0 {
+ reg = <0>;
+
+ csi2tx_out: endpoint {
+ remote-endpoint = <&remote_in>;
+ clock-lanes = <0>;
+ data-lanes = <1 2>;
+ };
+ };
+
+ port@1 {
+ reg = <1>;
+
+ csi2tx_in_stream0: endpoint {
+ remote-endpoint = <&stream0_out>;
+ };
+ };
+
+ port@2 {
+ reg = <2>;
+
+ csi2tx_in_stream1: endpoint {
+ remote-endpoint = <&stream1_out>;
+ };
+ };
+
+ port@3 {
+ reg = <3>;
+
+ csi2tx_in_stream2: endpoint {
+ remote-endpoint = <&stream2_out>;
+ };
+ };
+
+ port@4 {
+ reg = <4>;
+
+ csi2tx_in_stream3: endpoint {
+ remote-endpoint = <&stream3_out>;
+ };
+ };
+ };
+};