@@ -68,14 +68,17 @@ void __init omap2_set_globals_cm(void __iomem *cm, void __iomem *cm2)
int cm_split_idlest_reg(struct clk_omap_reg *idlest_reg, s16 *prcm_inst,
u8 *idlest_reg_id)
{
+ int ret;
if (!cm_ll_data->split_idlest_reg) {
WARN_ONCE(1, "cm: %s: no low-level function defined\n",
__func__);
return -EINVAL;
}
- return cm_ll_data->split_idlest_reg(idlest_reg, prcm_inst,
+ ret = cm_ll_data->split_idlest_reg(idlest_reg, prcm_inst,
idlest_reg_id);
+ *prcm_inst -= cm_base.offset;
+ return ret;
}
/**
@@ -347,6 +350,7 @@ int __init omap2_cm_base_init(void)
if (mem) {
mem->pa = res.start + data->offset;
mem->va = data->mem + data->offset;
+ mem->offset = data->offset;
}
data->np = np;
@@ -529,6 +529,7 @@ struct omap_prcm_irq_setup {
struct omap_domain_base {
u32 pa;
void __iomem *va;
+ s16 offset;
};
/**
cm_split_idlest doesn't take the CM base offset into account right now, causing it to read reserved registers which show idlestatus as active always. This will cause the wait_module_ready functionality to be effectively an expensive NOP, which will cause problems if the module hasn't really activated during its execution. Fix by adding the CM offset into the calculation so the wait_module_ready will access correct register. Signed-off-by: Tero Kristo <t-kristo@ti.com> Reported-by: Filip Matijevic <filip.matijevic.pz@gmail.com> --- arch/arm/mach-omap2/cm_common.c | 6 +++++- arch/arm/mach-omap2/prcm-common.h | 1 + 2 files changed, 6 insertions(+), 1 deletion(-) -- 1.9.1 -- Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki -- To unsubscribe from this list: send the line "unsubscribe linux-omap" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html