new file mode 100644
@@ -0,0 +1,49 @@
+The Imagination Technologies SPDIF Input controller contains the following
+controls:
+
+name='IEC958 Capture Mask',index=0
+
+This control returns a mask that shows which of the IEC958 status bits
+can be read using the 'IEC958 Capture Default' control.
+
+name='IEC958 Capture Default',index=0
+
+This control returns the status bits contained within the SPDIF stream that
+is being received. The 'IEC958 Capture Mask' shows which bits can be read
+from this control.
+
+name='SPDIF In Multi Frequency Acquire',index=0
+name='SPDIF In Multi Frequency Acquire',index=1
+name='SPDIF In Multi Frequency Acquire',index=2
+name='SPDIF In Multi Frequency Acquire',index=3
+
+This control is used to attempt acquisition of up to four different sample
+rates. The active rate can be obtained by reading the 'SPDIF In Lock Frequency'
+control.
+
+When the value of this control is set to {0,0,0,0}, the rate given to hw_params
+will determine the single rate the block will capture. Else, the rate given to
+hw_params will be ignored, and the block will attempt capture for each of the
+four sample rates set here.
+
+If less than four rates are required, the same rate can be specified more than
+once
+
+name='SPDIF In Lock Frequency',index=0
+
+This control returns the active capture rate, or 0 if a lock has not been
+acquired
+
+name='SPDIF In Lock TRK',index=0
+
+This control is used to modify the locking/jitter rejection characteristics
+of the block. Larger values increase the locking range, but reduce jitter
+rejection.
+
+name='SPDIF In Lock Acquire Threshold',index=0
+
+This control is used to change the threshold at which a lock is acquired.
+
+name='SPDIF In Lock Release Threshold',index=0
+
+This control is used to change the threshold at which a lock is released.