@@ -3,6 +3,8 @@
Required properties:
- compatible : should be one of the following:
"altr,socfpga-denali-nand" - for Altera SOCFPGA
+ "socionext,uniphier-denali-nand-v5a" - for Socionext UniPhier (v5a)
+ "socionext,uniphier-denali-nand-v5b" - for Socionext UniPhier (v5b)
- reg : should contain registers location and length for data and reg.
- reg-names: Should contain the reg names "nand_data" and "denali_reg"
- interrupts : The interrupt number.
@@ -10,8 +12,12 @@ Required properties:
Optional properties:
- nand-ecc-step-size: see nand.txt for details. If present, the value must be
512 for "altr,socfpga-denali-nand"
+ 1024 for "socionext,uniphier-denali-nand-v5a"
+ 1024 for "socionext,uniphier-denali-nand-v5b"
- nand-ecc-strength: see nand.txt for details. Valid values are:
8, 15 for "altr,socfpga-denali-nand"
+ 8, 16, 24 for "socionext,uniphier-denali-nand-v5a"
+ 8, 16 for "socionext,uniphier-denali-nand-v5b"
- nand-ecc-maximize: see nand.txt for details
The device tree may optionally contain sub-nodes describing partitions of the
@@ -42,11 +42,36 @@ static const struct denali_dt_data denali_socfpga_data = {
.ecc_caps = &denali_socfpga_ecc_caps,
};
+NAND_ECC_CAPS_SINGLE(denali_uniphier_v5a_ecc_caps, denali_calc_ecc_bytes,
+ 1024, 8, 16, 24);
+static const struct denali_dt_data denali_uniphier_v5a_data = {
+ .caps = DENALI_CAP_HW_ECC_FIXUP |
+ DENALI_CAP_DMA_64BIT,
+ .ecc_caps = &denali_uniphier_v5a_ecc_caps,
+};
+
+NAND_ECC_CAPS_SINGLE(denali_uniphier_v5b_ecc_caps, denali_calc_ecc_bytes,
+ 1024, 8, 16);
+static const struct denali_dt_data denali_uniphier_v5b_data = {
+ .revision = 0x0501,
+ .caps = DENALI_CAP_HW_ECC_FIXUP |
+ DENALI_CAP_DMA_64BIT,
+ .ecc_caps = &denali_uniphier_v5b_ecc_caps,
+};
+
static const struct of_device_id denali_nand_dt_ids[] = {
{
.compatible = "altr,socfpga-denali-nand",
.data = &denali_socfpga_data,
},
+ {
+ .compatible = "socionext,uniphier-denali-nand-v5a",
+ .data = &denali_uniphier_v5a_data,
+ },
+ {
+ .compatible = "socionext,uniphier-denali-nand-v5b",
+ .data = &denali_uniphier_v5b_data,
+ },
{ /* sentinel */ }
};
MODULE_DEVICE_TABLE(of, denali_nand_dt_ids);
Add two compatible strings for UniPhier SoC family. "socionext,uniphier-denali-nand-v5a" is used on UniPhier sLD3, LD4, Pro4, sLD8. "socionext,uniphier-denali-nand-v5b" is used on UniPhier Pro5, PXs2, LD6b, LD11, LD20. Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com> --- Changes in v5: - Adjust to the update of generic helpers Changes in v4: - Adjusted to generic helpers for ECC engine caps Changes in v3: None Changes in v2: - Change the compatible strings - Fix the ecc_strength_capability - Override revision number for the newer one .../devicetree/bindings/mtd/denali-nand.txt | 6 ++++++ drivers/mtd/nand/denali_dt.c | 25 ++++++++++++++++++++++ 2 files changed, 31 insertions(+) -- 2.7.4