@@ -1446,7 +1446,8 @@ int denali_init(struct denali_nand_info *denali)
"chosen ECC settings: step=%d, strength=%d, bytes=%d\n",
chip->ecc.size, chip->ecc.strength, chip->ecc.bytes);
- iowrite32(chip->ecc.strength, denali->flash_reg + ECC_CORRECTION);
+ iowrite32(MAKE_ECC_CORRECTION(chip->ecc.strength, 1),
+ denali->flash_reg + ECC_CORRECTION);
iowrite32(mtd->erasesize / mtd->writesize,
denali->flash_reg + PAGES_PER_BLOCK);
iowrite32(chip->options & NAND_BUSWIDTH_16 ? 1 : 0,
@@ -110,6 +110,10 @@
#define ECC_CORRECTION 0x1b0
#define ECC_CORRECTION__VALUE GENMASK(4, 0)
+#define ECC_CORRECTION__ERASE_THRESHOLD GENMASK(31, 16)
+#define MAKE_ECC_CORRECTION(val, thresh) \
+ (((val) & (ECC_CORRECTION__VALUE)) | \
+ (((thresh) << 16) & (ECC_CORRECTION__ERASE_THRESHOLD)))
#define READ_MODE 0x1c0
#define READ_MODE__VALUE GENMASK(3, 0)
@@ -233,6 +237,7 @@
#define INTR__RST_COMP BIT(13)
#define INTR__PIPE_CMD_ERR BIT(14)
#define INTR__PAGE_XFER_INC BIT(15)
+#define INTR__ERASED_PAGE BIT(16)
#define PAGE_CNT(bank) (0x430 + (bank) * 0x50)
#define ERR_PAGE_ADDR(bank) (0x440 + (bank) * 0x50)
Recent versions of this IP support automatic erased page detection. If an erased page is detected on reads, the controller does not set INTR__ECC_UNCOR_ERR, but INTR__ERASED_PAGE. The detection of erased page is based on the number of zeros in a page; if the number of zeros is less than the value in the field ERASED_THRESHOLD, the page is assumed as erased. Please note ERASED_THRESHOLD specifies the number of zeros in a _page_ instead of an ECC chunk. Moreover, the controller does not provide a way to know the actual number of bitflips. Actually, an erased page (all 0xff) is not an ECC correctable pattern on the Denali ECC engine. In other words, there is overlap between the following two: [1] a bit pattern reachable from a valid payload + ECC pattern within ecc.strength bitflips [2] a bit pattern reachable from an erased state (all 0xff) within ecc.strength bitflips So, this feature may intercept ECC correctable patterns, then replace [1] with [2]. After all, this feature can work safely only when ECC_THRESHOLD == 1, i.e. detect erased pages without any bitflips. This should be the case most of the time. If there are some bitflips, the driver will fallback to the software method by using nand_check_erased_ecc_chunk(). Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com> --- Changes in v5: - Set ECC_THRESHOLD to 1 Changes in v4: None Changes in v3: None Changes in v2: - Newly added drivers/mtd/nand/denali.c | 3 ++- drivers/mtd/nand/denali.h | 5 +++++ 2 files changed, 7 insertions(+), 1 deletion(-) -- 2.7.4