@@ -214,6 +214,7 @@ static struct rtl8xxxu_reg8val rtl8192e_mac_init_table[] = {
{0xffff, 0xff},
};
+#ifdef CONFIG_RTL8XXXU_UNTESTED
static struct rtl8xxxu_power_base rtl8188r_power_base = {
.reg_0e00 = 0x06080808,
.reg_0e04 = 0x00040406,
@@ -257,6 +258,7 @@ static struct rtl8xxxu_power_base rtl8192c_power_base = {
.reg_084c = 0x0b0c0d0e,
.reg_0868 = 0x01030509,
};
+#endif
static struct rtl8xxxu_power_base rtl8723a_power_base = {
.reg_0e00 = 0x0a0c0c0c,
@@ -1329,6 +1331,7 @@ static struct rtl8xxxu_rfregval rtl8723bu_radioa_1t_init_table[] = {
{0xff, 0xffffffff}
};
+#ifdef CONFIG_RTL8XXXU_UNTESTED
static struct rtl8xxxu_rfregval rtl8192cu_radioa_2t_init_table[] = {
{0x00, 0x00030159}, {0x01, 0x00031284},
{0x02, 0x00098000}, {0x03, 0x00018c63},
@@ -1577,6 +1580,7 @@ static struct rtl8xxxu_rfregval rtl8188ru_radioa_1t_highpa_table[] = {
{0x00, 0x00030159},
{0xff, 0xffffffff}
};
+#endif
static struct rtl8xxxu_rfregval rtl8192eu_radioa_init_table[] = {
{0x7f, 0x00000082}, {0x81, 0x0003fc00},
The references to some arrays in the rtl8xxxu driver were moved inside of an #ifdef, but the symbols remain outside, resulting in build warnings: rtl8xxxu/rtl8xxxu.c:1506:33: error: 'rtl8188ru_radioa_1t_highpa_table' defined but not used rtl8xxxu/rtl8xxxu.c:1431:33: error: 'rtl8192cu_radioa_1t_init_table' defined but not used rtl8xxxu/rtl8xxxu.c:1407:33: error: 'rtl8192cu_radiob_2t_init_table' defined but not used rtl8xxxu/rtl8xxxu.c:1332:33: error: 'rtl8192cu_radioa_2t_init_table' defined but not used rtl8xxxu/rtl8xxxu.c:239:35: error: 'rtl8192c_power_base' defined but not used rtl8xxxu/rtl8xxxu.c:217:35: error: 'rtl8188r_power_base' defined but not used This adds an extra #ifdef around them to shut up the warnings. Signed-off-by: Arnd Bergmann <arnd@arndb.de> Fixes: 2fc0b8e5a17d ("rtl8xxxu: Add TX power base values for gen1 parts") Fixes: 4062b8ffec36 ("rtl8xxxu: Move PHY RF init into device specific functions") --- drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c | 4 ++++ 1 file changed, 4 insertions(+) -- 2.7.0