@@ -711,6 +711,10 @@ The following options need to be configured:
boot loader that has already initialized the UART. Define this
variable to flush the UART at init time.
+ CONFIG_SERIAL_HW_FLOW_CONTROL
+
+ Define this variable to enable hw flow control in serial driver.
+ Current user of this option is drivers/serial/nsl16550.c driver
- Console Interface:
Depending on board, define exactly one serial port
@@ -33,6 +33,12 @@
#if defined(CONFIG_K2HK_EVM)
#define UART_REG_VAL_PWREMU_MGMT_UART_DISABLE 0
#define UART_REG_VAL_PWREMU_MGMT_UART_ENABLE ((1 << 14) | (1 << 13) | (1 << 0))
+#undef UART_MCRVAL
+#ifdef CONFIG_SERIAL_HW_FLOW_CONTROL
+#define UART_MCRVAL (UART_MCR_RTS | UART_MCR_AFE)
+#else
+#define UART_MCRVAL (UART_MCR_RTS)
+#endif
#endif
#ifndef CONFIG_SYS_NS16550_IER
@@ -100,6 +100,7 @@ typedef struct NS16550 *NS16550_t;
#define UART_MCR_OUT1 0x04 /* Out 1 */
#define UART_MCR_OUT2 0x08 /* Out 2 */
#define UART_MCR_LOOP 0x10 /* Enable loopback test mode */
+#define UART_MCR_AFE 0x20 /* Enable auto-RTS/CTS */
#define UART_MCR_DMA_EN 0x04
#define UART_MCR_TX_DFR 0x08
keystone serial hw support hw flow control. This patch enables hw flow control for keystone EVMs as an optional feature based on CONFIG_SERIAL_HW_FLOW_CONTROL. Signed-off-by: Murali Karicheri <m-karicheri2@ti.com> --- depends on keystone patch series which is on the list. README | 4 ++++ drivers/serial/ns16550.c | 6 ++++++ include/ns16550.h | 1 + 3 files changed, 11 insertions(+)