| Message ID | 20240912-test-v1-0-458fa57c8ccf@analog.com |
|---|---|
| Headers | show |
| Series | Adding support of ADI ARMv8 ADSP-SC598 SoC. | expand |
On 12/09/2024 23:04, Rob Herring (Arm) wrote: > > On Thu, 12 Sep 2024 19:24:45 +0100, Arturs Artamonovs wrote: >> This set of patches based on ADI fork of Linux Kerenl that support family of ADSP-SC5xx >> SoC's and used by customers for some time . Patch series contains minimal set >> of changes to add ADSP-SC598 support to upstream kernel. This series include >> UART,I2C,IRQCHIP,RCU drivers and device-tree to be able boot on EV-SC598-SOM >> board into serial shell and able to reset the board. Current SOM board >> requires I2C expander to enable UART output. >> >> UART,I2C and PINCTRL drivers are based on old Blackfin drivers with >> ADSP-SC5xx related bug fixes and improvments. >> >> Signed-off-by: Arturs Artamonovs <arturs.artamonovs@analog.com> >> --- >> Arturs Artamonovs (21): >> arm64: Add ADI ADSP-SC598 SoC >> reset: Add driver for ADI ADSP-SC5xx reset controller >> dt-bindigs: arm64: adi,sc598 bindings >> dt-bindings: arm64: adi,sc598: Add ADSP-SC598 SoC bindings >> clock:Add driver for ADI ADSP-SC5xx PLL >> include: dt-binding: clock: add adi clock header file >> clock: Add driver for ADI ADSP-SC5xx clock >> dt-bindings: clock: adi,sc5xx-clocks: add bindings >> gpio: add driver for ADI ADSP-SC5xx platform >> dt-bindings: gpio: adi,adsp-port-gpio: add bindings >> irqchip: Add irqchip for ADI ADSP-SC5xx platform >> dt-bindings: irqchip: adi,adsp-pint: add binding >> pinctrl: Add drivers for ADI ADSP-SC5xx platform >> dt-bindings: pinctrl: adi,adsp-pinctrl: add bindings >> i2c: Add driver for ADI ADSP-SC5xx platforms >> dt-bindings: i2c: add i2c/twi driver documentation >> serial: adi,uart: Add driver for ADI ADSP-SC5xx >> dt-bindings: serial: adi,uart4: add adi,uart4 driver documentation >> arm64: dts: adi: sc598: add device tree >> arm64: defconfig: sc598 add minimal changes >> MAINTAINERS: add adi sc5xx maintainers >> >> .../devicetree/bindings/arm/analog/adi,sc5xx.yaml | 24 + >> .../bindings/clock/adi,sc5xx-clocks.yaml | 65 ++ >> .../bindings/gpio/adi,adsp-port-gpio.yaml | 69 ++ >> Documentation/devicetree/bindings/i2c/adi,twi.yaml | 71 ++ >> .../interrupt-controller/adi,adsp-pint.yaml | 51 + >> .../bindings/pinctrl/adi,adsp-pinctrl.yaml | 83 ++ >> .../devicetree/bindings/serial/adi,uart.yaml | 85 ++ >> .../bindings/soc/adi/adi,reset-controller.yaml | 38 + >> MAINTAINERS | 22 + >> arch/arm64/Kconfig.platforms | 13 + >> arch/arm64/boot/dts/Makefile | 1 + >> arch/arm64/boot/dts/adi/Makefile | 2 + >> arch/arm64/boot/dts/adi/sc598-som-ezkit.dts | 14 + >> arch/arm64/boot/dts/adi/sc598-som.dtsi | 58 ++ >> arch/arm64/boot/dts/adi/sc59x-64.dtsi | 367 +++++++ >> arch/arm64/configs/defconfig | 6 + >> drivers/clk/Kconfig | 9 + >> drivers/clk/Makefile | 1 + >> drivers/clk/adi/Makefile | 4 + >> drivers/clk/adi/clk-adi-pll.c | 151 +++ >> drivers/clk/adi/clk-adi-sc598.c | 329 ++++++ >> drivers/clk/adi/clk.h | 99 ++ >> drivers/gpio/Kconfig | 8 + >> drivers/gpio/Makefile | 1 + >> drivers/gpio/gpio-adi-adsp-port.c | 145 +++ >> drivers/i2c/busses/Kconfig | 17 + >> drivers/i2c/busses/Makefile | 1 + >> drivers/i2c/busses/i2c-adi-twi.c | 940 ++++++++++++++++++ >> drivers/irqchip/Kconfig | 9 + >> drivers/irqchip/Makefile | 2 + >> drivers/irqchip/irq-adi-adsp.c | 310 ++++++ >> drivers/pinctrl/Kconfig | 12 + >> drivers/pinctrl/Makefile | 1 + >> drivers/pinctrl/pinctrl-adsp.c | 919 +++++++++++++++++ >> drivers/reset/Makefile | 1 + >> drivers/soc/Makefile | 1 + >> drivers/soc/adi/Makefile | 5 + >> drivers/soc/adi/system.c | 257 +++++ >> drivers/tty/serial/Kconfig | 19 +- >> drivers/tty/serial/Makefile | 1 + >> drivers/tty/serial/adi_uart.c | 1045 ++++++++++++++++++++ >> include/dt-bindings/clock/adi-sc5xx-clock.h | 93 ++ >> include/dt-bindings/pinctrl/adi-adsp.h | 19 + >> include/linux/soc/adi/adsp-gpio-port.h | 85 ++ >> include/linux/soc/adi/cpu.h | 107 ++ >> include/linux/soc/adi/rcu.h | 55 ++ >> include/linux/soc/adi/sc59x.h | 147 +++ >> include/linux/soc/adi/system_config.h | 65 ++ >> include/uapi/linux/serial_core.h | 3 + >> 49 files changed, 5829 insertions(+), 1 deletion(-) >> --- >> base-commit: da3ea35007d0af457a0afc87e84fddaebc4e0b63 >> change-id: 20240909-test-8ec5f76fe6d2 >> >> Best regards, >> -- >> Arturs Artamonovs <arturs.artamonovs@analog.com> >> >> >> > > > My bot found new DTB warnings on the .dts files added or changed in this > series. > > Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings > are fixed by another series. Ultimately, it is up to the platform > maintainer whether these warnings are acceptable or not. No need to reply > unless the platform maintainer has comments. > > If you already ran DT checks and didn't see these error(s), then > make sure dt-schema is up to date: > > pip3 install dtschema --upgrade > > > New warnings running 'make CHECK_DTBS=y adi/sc598-som-ezkit.dtb' for 20240912-test-v1-0-458fa57c8ccf@analog.com: > > arch/arm64/boot/dts/adi/sc598-som-ezkit.dtb: /scb-bus/sec@31089000: failed to match any schema with compatible: ['adi,system-event-controller'] This must be addressed and fixed. Best regards, Krzysztof
This set of patches based on ADI fork of Linux Kerenl that support family of ADSP-SC5xx SoC's and used by customers for some time . Patch series contains minimal set of changes to add ADSP-SC598 support to upstream kernel. This series include UART,I2C,IRQCHIP,RCU drivers and device-tree to be able boot on EV-SC598-SOM board into serial shell and able to reset the board. Current SOM board requires I2C expander to enable UART output. UART,I2C and PINCTRL drivers are based on old Blackfin drivers with ADSP-SC5xx related bug fixes and improvments. Signed-off-by: Arturs Artamonovs <arturs.artamonovs@analog.com> --- Arturs Artamonovs (21): arm64: Add ADI ADSP-SC598 SoC reset: Add driver for ADI ADSP-SC5xx reset controller dt-bindigs: arm64: adi,sc598 bindings dt-bindings: arm64: adi,sc598: Add ADSP-SC598 SoC bindings clock:Add driver for ADI ADSP-SC5xx PLL include: dt-binding: clock: add adi clock header file clock: Add driver for ADI ADSP-SC5xx clock dt-bindings: clock: adi,sc5xx-clocks: add bindings gpio: add driver for ADI ADSP-SC5xx platform dt-bindings: gpio: adi,adsp-port-gpio: add bindings irqchip: Add irqchip for ADI ADSP-SC5xx platform dt-bindings: irqchip: adi,adsp-pint: add binding pinctrl: Add drivers for ADI ADSP-SC5xx platform dt-bindings: pinctrl: adi,adsp-pinctrl: add bindings i2c: Add driver for ADI ADSP-SC5xx platforms dt-bindings: i2c: add i2c/twi driver documentation serial: adi,uart: Add driver for ADI ADSP-SC5xx dt-bindings: serial: adi,uart4: add adi,uart4 driver documentation arm64: dts: adi: sc598: add device tree arm64: defconfig: sc598 add minimal changes MAINTAINERS: add adi sc5xx maintainers .../devicetree/bindings/arm/analog/adi,sc5xx.yaml | 24 + .../bindings/clock/adi,sc5xx-clocks.yaml | 65 ++ .../bindings/gpio/adi,adsp-port-gpio.yaml | 69 ++ Documentation/devicetree/bindings/i2c/adi,twi.yaml | 71 ++ .../interrupt-controller/adi,adsp-pint.yaml | 51 + .../bindings/pinctrl/adi,adsp-pinctrl.yaml | 83 ++ .../devicetree/bindings/serial/adi,uart.yaml | 85 ++ .../bindings/soc/adi/adi,reset-controller.yaml | 38 + MAINTAINERS | 22 + arch/arm64/Kconfig.platforms | 13 + arch/arm64/boot/dts/Makefile | 1 + arch/arm64/boot/dts/adi/Makefile | 2 + arch/arm64/boot/dts/adi/sc598-som-ezkit.dts | 14 + arch/arm64/boot/dts/adi/sc598-som.dtsi | 58 ++ arch/arm64/boot/dts/adi/sc59x-64.dtsi | 367 +++++++ arch/arm64/configs/defconfig | 6 + drivers/clk/Kconfig | 9 + drivers/clk/Makefile | 1 + drivers/clk/adi/Makefile | 4 + drivers/clk/adi/clk-adi-pll.c | 151 +++ drivers/clk/adi/clk-adi-sc598.c | 329 ++++++ drivers/clk/adi/clk.h | 99 ++ drivers/gpio/Kconfig | 8 + drivers/gpio/Makefile | 1 + drivers/gpio/gpio-adi-adsp-port.c | 145 +++ drivers/i2c/busses/Kconfig | 17 + drivers/i2c/busses/Makefile | 1 + drivers/i2c/busses/i2c-adi-twi.c | 940 ++++++++++++++++++ drivers/irqchip/Kconfig | 9 + drivers/irqchip/Makefile | 2 + drivers/irqchip/irq-adi-adsp.c | 310 ++++++ drivers/pinctrl/Kconfig | 12 + drivers/pinctrl/Makefile | 1 + drivers/pinctrl/pinctrl-adsp.c | 919 +++++++++++++++++ drivers/reset/Makefile | 1 + drivers/soc/Makefile | 1 + drivers/soc/adi/Makefile | 5 + drivers/soc/adi/system.c | 257 +++++ drivers/tty/serial/Kconfig | 19 +- drivers/tty/serial/Makefile | 1 + drivers/tty/serial/adi_uart.c | 1045 ++++++++++++++++++++ include/dt-bindings/clock/adi-sc5xx-clock.h | 93 ++ include/dt-bindings/pinctrl/adi-adsp.h | 19 + include/linux/soc/adi/adsp-gpio-port.h | 85 ++ include/linux/soc/adi/cpu.h | 107 ++ include/linux/soc/adi/rcu.h | 55 ++ include/linux/soc/adi/sc59x.h | 147 +++ include/linux/soc/adi/system_config.h | 65 ++ include/uapi/linux/serial_core.h | 3 + 49 files changed, 5829 insertions(+), 1 deletion(-) --- base-commit: da3ea35007d0af457a0afc87e84fddaebc4e0b63 change-id: 20240909-test-8ec5f76fe6d2 Best regards,