diff mbox series

[v2,2/2] dt-bindings: leds: Read max-brightness from devicetree

Message ID 20230630092248.4146169-3-astrid.rost@axis.com
State New
Headers show
Series [v2,1/2] led: led-class: Read max-brightness from devicetree | expand

Commit Message

Astrid Rost June 30, 2023, 9:22 a.m. UTC
Add max-brightness in order to reduce the current on the connected LEDs.
Normally, the maximum brightness is determined by the hardware, and this
property is not required. This property is used to set a software limit.
It could happen that an LED is made so bright that it gets damaged or
causes damage due to restrictions in a specific system, such as mounting
conditions. Note that led-max-microamp should be preferably used, if it
is supported by the controller.

Signed-off-by: Astrid Rost <astrid.rost@axis.com>
---
 Documentation/devicetree/bindings/leds/common.yaml | 10 ++++++++++
 1 file changed, 10 insertions(+)

Comments

Rob Herring (Arm) June 30, 2023, 4:49 p.m. UTC | #1
On Fri, Jun 30, 2023 at 11:22:47AM +0200, Astrid Rost wrote:
> Add max-brightness in order to reduce the current on the connected LEDs.
> Normally, the maximum brightness is determined by the hardware, and this
> property is not required. This property is used to set a software limit.
> It could happen that an LED is made so bright that it gets damaged or
> causes damage due to restrictions in a specific system, such as mounting
> conditions. Note that led-max-microamp should be preferably used, if it
> is supported by the controller.
> 
> Signed-off-by: Astrid Rost <astrid.rost@axis.com>
> ---
>  Documentation/devicetree/bindings/leds/common.yaml | 10 ++++++++++
>  1 file changed, 10 insertions(+)

The patch order is wrong. You have to define a property before you can 
use it. Otherwise,

Reviewed-by: Rob Herring <robh@kernel.org>
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/leds/common.yaml b/Documentation/devicetree/bindings/leds/common.yaml
index 11aedf1650a1..603a5630fc3d 100644
--- a/Documentation/devicetree/bindings/leds/common.yaml
+++ b/Documentation/devicetree/bindings/leds/common.yaml
@@ -160,6 +160,16 @@  properties:
       For flash LED controllers with configurable current this property is
       mandatory for the LEDs in the non-flash modes (e.g. torch or indicator).
 
+  max-brightness:
+    description:
+      Normally, the maximum brightness is determined by the hardware, and
+      this property is not required. This property is used to set a software
+      limit. It could happen that an LED is made so bright that it gets damaged
+      or causes damage due to restrictions in a specific system, such as
+      mounting conditions. Note that led-max-microamp should be preferably used,
+      if it is supported by the controller.
+    $ref: /schemas/types.yaml#definitions/uint32
+
   panic-indicator:
     description:
       This property specifies that the LED should be used, if at all possible,