| Message ID | 20220225073922.3947-6-yu.tu@amlogic.com |
|---|---|
| State | New |
| Headers | show |
| Series | Use CCF to describe the UART baud rate clock | expand |
Hi Jerome, Thank you for your reply. On 2022/2/28 18:58, Jerome Brunet wrote: > [ EXTERNAL EMAIL ] > > > On Fri 25 Feb 2022 at 15:39, Yu Tu <yu.tu@amlogic.com> wrote: > >> Start the console and run the following commands in turn: >> stty -F /dev/ttyAML0 115200 and stty -F /dev/ttyAML0 921600. The >> system will stuck. >> >> Signed-off-by: Yu Tu <yu.tu@amlogic.com> >> --- >> drivers/tty/serial/meson_uart.c | 5 +++++ >> 1 file changed, 5 insertions(+) >> >> diff --git a/drivers/tty/serial/meson_uart.c b/drivers/tty/serial/meson_uart.c >> index ba8dc203b9cb..d19349ead738 100644 >> --- a/drivers/tty/serial/meson_uart.c >> +++ b/drivers/tty/serial/meson_uart.c >> @@ -365,8 +365,13 @@ static void meson_uart_set_termios(struct uart_port *port, >> writel(val, port->membase + AML_UART_CONTROL); >> >> baud = uart_get_baud_rate(port, termios, old, 50, 4000000); >> + >> + spin_unlock_irqrestore(&port->lock, flags); >> + >> meson_uart_change_speed(port, baud); >> >> + spin_lock_irqsave(&port->lock, flags); > > Already told you before, you can make meson_change_speed() > clk_set_rate() uses mutex and may sleep. Sorry, I may have only paid attention to how you asked me to change to using the clock before, instead of paying attention to this suggestion. > >> + >> port->read_status_mask = AML_UART_TX_FIFO_WERR; >> if (iflags & INPCK) >> port->read_status_mask |= AML_UART_PARITY_ERR | >
diff --git a/drivers/tty/serial/meson_uart.c b/drivers/tty/serial/meson_uart.c index ba8dc203b9cb..d19349ead738 100644 --- a/drivers/tty/serial/meson_uart.c +++ b/drivers/tty/serial/meson_uart.c @@ -365,8 +365,13 @@ static void meson_uart_set_termios(struct uart_port *port, writel(val, port->membase + AML_UART_CONTROL); baud = uart_get_baud_rate(port, termios, old, 50, 4000000); + + spin_unlock_irqrestore(&port->lock, flags); + meson_uart_change_speed(port, baud); + spin_lock_irqsave(&port->lock, flags); + port->read_status_mask = AML_UART_TX_FIFO_WERR; if (iflags & INPCK) port->read_status_mask |= AML_UART_PARITY_ERR |
Start the console and run the following commands in turn: stty -F /dev/ttyAML0 115200 and stty -F /dev/ttyAML0 921600. The system will stuck. Signed-off-by: Yu Tu <yu.tu@amlogic.com> --- drivers/tty/serial/meson_uart.c | 5 +++++ 1 file changed, 5 insertions(+)