@@ -64,7 +64,7 @@ correct address for this module, you could get in big trouble (read:
crashes, data corruption, etc.). Try this only as a last resort (try BIOS
updates first, for example), and backup first! An even more dangerous
option is 'force_addr=<IOPORT>'. This will not only enable the PIIX4 like
-'force' foes, but it will also set a new base I/O port address. The SMBus
+'force' does, but it will also set a new base I/O port address. The SMBus
parts of the PIIX4 needs a range of 8 of these addresses to function
correctly. If these addresses are already reserved by some other device,
you will get into big trouble! DON'T USE THIS IF YOU ARE NOT VERY SURE
@@ -86,15 +86,15 @@ If you own Force CPCI735 motherboard or other OSB4 based systems you may need
to change the SMBus Interrupt Select register so the SMBus controller uses
the SMI mode.
-1) Use lspci command and locate the PCI device with the SMBus controller:
+1) Use ``lspci`` command and locate the PCI device with the SMBus controller:
00:0f.0 ISA bridge: ServerWorks OSB4 South Bridge (rev 4f)
The line may vary for different chipsets. Please consult the driver source
- for all possible PCI ids (and lspci -n to match them). Lets assume the
+ for all possible PCI ids (and ``lspci -n`` to match them). Lets assume the
device is located at 00:0f.0.
2) Now you just need to change the value in 0xD2 register. Get it first with
- command: lspci -xxx -s 00:0f.0
+ command: ``lspci -xxx -s 00:0f.0``
If the value is 0x3 then you need to change it to 0x1:
- setpci -s 00:0f.0 d2.b=1
+ ``setpci -s 00:0f.0 d2.b=1``
Please note that you don't need to do that in all cases, just when the SMBus is
not working properly.
@@ -111,4 +111,4 @@ of all affected systems, so the only safe solution was to prevent access to
the SMBus on all IBM systems (detected using DMI data.)
For additional information, read:
-http://www.lm-sensors.org/browser/lm-sensors/trunk/README
+https://hwmon.wiki.kernel.org
http://lm-sensors.org no longer exists, https://github.com/lm-sensors/lm-sensors/issues/3 suggests using https://hwmon.wiki.kernel.org/ Signed-off-by: Bruce Duncan <bwduncan@gmail.com> --- Documentation/i2c/busses/i2c-piix4.rst | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-)