| Message ID | 20210526043037.9830-4-o.rempel@pengutronix.de |
|---|---|
| State | New |
| Headers | show |
| Series | provide cable test support for the ksz886x switch | expand |
On Wed, May 26, 2021 at 06:30:31AM +0200, Oleksij Rempel wrote: > This patch changes the indention to one space between "#define" and the indention /ɪnˈdɛnʃ(ə)n/ noun noun: indention; plural noun: indentions archaic term for indentation. Interesting, I learned something new. Also, technically it's alignment not indentation. > macro. > > Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de> > --- > drivers/net/phy/micrel.c | 24 ++++++++++++------------ > 1 file changed, 12 insertions(+), 12 deletions(-) > > diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c > index a14a00328fa3..227d88db7d27 100644 > --- a/drivers/net/phy/micrel.c > +++ b/drivers/net/phy/micrel.c > @@ -38,15 +38,15 @@ > > /* general Interrupt control/status reg in vendor specific block. */ > #define MII_KSZPHY_INTCS 0x1B > -#define KSZPHY_INTCS_JABBER BIT(15) > -#define KSZPHY_INTCS_RECEIVE_ERR BIT(14) > -#define KSZPHY_INTCS_PAGE_RECEIVE BIT(13) > -#define KSZPHY_INTCS_PARELLEL BIT(12) > -#define KSZPHY_INTCS_LINK_PARTNER_ACK BIT(11) > -#define KSZPHY_INTCS_LINK_DOWN BIT(10) > -#define KSZPHY_INTCS_REMOTE_FAULT BIT(9) > -#define KSZPHY_INTCS_LINK_UP BIT(8) > -#define KSZPHY_INTCS_ALL (KSZPHY_INTCS_LINK_UP |\ > +#define KSZPHY_INTCS_JABBER BIT(15) > +#define KSZPHY_INTCS_RECEIVE_ERR BIT(14) > +#define KSZPHY_INTCS_PAGE_RECEIVE BIT(13) > +#define KSZPHY_INTCS_PARELLEL BIT(12) > +#define KSZPHY_INTCS_LINK_PARTNER_ACK BIT(11) > +#define KSZPHY_INTCS_LINK_DOWN BIT(10) > +#define KSZPHY_INTCS_REMOTE_FAULT BIT(9) > +#define KSZPHY_INTCS_LINK_UP BIT(8) > +#define KSZPHY_INTCS_ALL (KSZPHY_INTCS_LINK_UP |\ > KSZPHY_INTCS_LINK_DOWN) > #define KSZPHY_INTCS_LINK_DOWN_STATUS BIT(2) > #define KSZPHY_INTCS_LINK_UP_STATUS BIT(0) You left these aligned using tabs. > @@ -54,11 +54,11 @@ > KSZPHY_INTCS_LINK_UP_STATUS) > > /* PHY Control 1 */ > -#define MII_KSZPHY_CTRL_1 0x1e > +#define MII_KSZPHY_CTRL_1 0x1e > > /* PHY Control 2 / PHY Control (if no PHY Control 1) */ > -#define MII_KSZPHY_CTRL_2 0x1f > -#define MII_KSZPHY_CTRL MII_KSZPHY_CTRL_2 > +#define MII_KSZPHY_CTRL_2 0x1f > +#define MII_KSZPHY_CTRL MII_KSZPHY_CTRL_2 > /* bitmap of PHY register to set interrupt mode */ > #define KSZPHY_CTRL_INT_ACTIVE_HIGH BIT(9) > #define KSZPHY_RMII_REF_CLK_SEL BIT(7) > -- > 2.29.2 > And the last column of these macros at the end is aligned with spaces unlike everything else: /* Write/read to/from extended registers */ #define MII_KSZPHY_EXTREG 0x0b #define KSZPHY_EXTREG_WRITE 0x8000 #define MII_KSZPHY_EXTREG_WRITE 0x0c #define MII_KSZPHY_EXTREG_READ 0x0d /* Extended registers */ #define MII_KSZPHY_CLK_CONTROL_PAD_SKEW 0x104 #define MII_KSZPHY_RX_DATA_PAD_SKEW 0x105 #define MII_KSZPHY_TX_DATA_PAD_SKEW 0x106 I guess if you're going to send this patch you might as well refactor it all.
On Thu, May 27, 2021 at 01:24:48AM +0300, Vladimir Oltean wrote: > On Wed, May 26, 2021 at 06:30:31AM +0200, Oleksij Rempel wrote: > > This patch changes the indention to one space between "#define" and the > > indention > /ɪnˈdɛnʃ(ə)n/ > noun > noun: indention; plural noun: indentions > > archaic term for indentation. > > Interesting, I learned something new. > > Also, technically it's alignment not indentation. ok, changed :) > > macro. > > > > Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de> > > --- > > drivers/net/phy/micrel.c | 24 ++++++++++++------------ > > 1 file changed, 12 insertions(+), 12 deletions(-) > > > > diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c > > index a14a00328fa3..227d88db7d27 100644 > > --- a/drivers/net/phy/micrel.c > > +++ b/drivers/net/phy/micrel.c > > @@ -38,15 +38,15 @@ > > > > /* general Interrupt control/status reg in vendor specific block. */ > > #define MII_KSZPHY_INTCS 0x1B > > -#define KSZPHY_INTCS_JABBER BIT(15) > > -#define KSZPHY_INTCS_RECEIVE_ERR BIT(14) > > -#define KSZPHY_INTCS_PAGE_RECEIVE BIT(13) > > -#define KSZPHY_INTCS_PARELLEL BIT(12) > > -#define KSZPHY_INTCS_LINK_PARTNER_ACK BIT(11) > > -#define KSZPHY_INTCS_LINK_DOWN BIT(10) > > -#define KSZPHY_INTCS_REMOTE_FAULT BIT(9) > > -#define KSZPHY_INTCS_LINK_UP BIT(8) > > -#define KSZPHY_INTCS_ALL (KSZPHY_INTCS_LINK_UP |\ > > +#define KSZPHY_INTCS_JABBER BIT(15) > > +#define KSZPHY_INTCS_RECEIVE_ERR BIT(14) > > +#define KSZPHY_INTCS_PAGE_RECEIVE BIT(13) > > +#define KSZPHY_INTCS_PARELLEL BIT(12) > > +#define KSZPHY_INTCS_LINK_PARTNER_ACK BIT(11) > > +#define KSZPHY_INTCS_LINK_DOWN BIT(10) > > +#define KSZPHY_INTCS_REMOTE_FAULT BIT(9) > > +#define KSZPHY_INTCS_LINK_UP BIT(8) > > +#define KSZPHY_INTCS_ALL (KSZPHY_INTCS_LINK_UP |\ > > KSZPHY_INTCS_LINK_DOWN) > > #define KSZPHY_INTCS_LINK_DOWN_STATUS BIT(2) > > #define KSZPHY_INTCS_LINK_UP_STATUS BIT(0) > > You left these aligned using tabs. done. > > @@ -54,11 +54,11 @@ > > KSZPHY_INTCS_LINK_UP_STATUS) > > > > /* PHY Control 1 */ > > -#define MII_KSZPHY_CTRL_1 0x1e > > +#define MII_KSZPHY_CTRL_1 0x1e > > > > /* PHY Control 2 / PHY Control (if no PHY Control 1) */ > > -#define MII_KSZPHY_CTRL_2 0x1f > > -#define MII_KSZPHY_CTRL MII_KSZPHY_CTRL_2 > > +#define MII_KSZPHY_CTRL_2 0x1f > > +#define MII_KSZPHY_CTRL MII_KSZPHY_CTRL_2 > > /* bitmap of PHY register to set interrupt mode */ > > #define KSZPHY_CTRL_INT_ACTIVE_HIGH BIT(9) > > #define KSZPHY_RMII_REF_CLK_SEL BIT(7) > > -- > > 2.29.2 > > > > And the last column of these macros at the end is aligned with spaces > unlike everything else: > > /* Write/read to/from extended registers */ > #define MII_KSZPHY_EXTREG 0x0b > #define KSZPHY_EXTREG_WRITE 0x8000 > > #define MII_KSZPHY_EXTREG_WRITE 0x0c > #define MII_KSZPHY_EXTREG_READ 0x0d > > /* Extended registers */ > #define MII_KSZPHY_CLK_CONTROL_PAD_SKEW 0x104 > #define MII_KSZPHY_RX_DATA_PAD_SKEW 0x105 > #define MII_KSZPHY_TX_DATA_PAD_SKEW 0x106 > > I guess if you're going to send this patch you might as well refactor it all. Ok, done. Regards, Oleksij -- Pengutronix e.K. | | Steuerwalder Str. 21 | http://www.pengutronix.de/ | 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 |
diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c index a14a00328fa3..227d88db7d27 100644 --- a/drivers/net/phy/micrel.c +++ b/drivers/net/phy/micrel.c @@ -38,15 +38,15 @@ /* general Interrupt control/status reg in vendor specific block. */ #define MII_KSZPHY_INTCS 0x1B -#define KSZPHY_INTCS_JABBER BIT(15) -#define KSZPHY_INTCS_RECEIVE_ERR BIT(14) -#define KSZPHY_INTCS_PAGE_RECEIVE BIT(13) -#define KSZPHY_INTCS_PARELLEL BIT(12) -#define KSZPHY_INTCS_LINK_PARTNER_ACK BIT(11) -#define KSZPHY_INTCS_LINK_DOWN BIT(10) -#define KSZPHY_INTCS_REMOTE_FAULT BIT(9) -#define KSZPHY_INTCS_LINK_UP BIT(8) -#define KSZPHY_INTCS_ALL (KSZPHY_INTCS_LINK_UP |\ +#define KSZPHY_INTCS_JABBER BIT(15) +#define KSZPHY_INTCS_RECEIVE_ERR BIT(14) +#define KSZPHY_INTCS_PAGE_RECEIVE BIT(13) +#define KSZPHY_INTCS_PARELLEL BIT(12) +#define KSZPHY_INTCS_LINK_PARTNER_ACK BIT(11) +#define KSZPHY_INTCS_LINK_DOWN BIT(10) +#define KSZPHY_INTCS_REMOTE_FAULT BIT(9) +#define KSZPHY_INTCS_LINK_UP BIT(8) +#define KSZPHY_INTCS_ALL (KSZPHY_INTCS_LINK_UP |\ KSZPHY_INTCS_LINK_DOWN) #define KSZPHY_INTCS_LINK_DOWN_STATUS BIT(2) #define KSZPHY_INTCS_LINK_UP_STATUS BIT(0) @@ -54,11 +54,11 @@ KSZPHY_INTCS_LINK_UP_STATUS) /* PHY Control 1 */ -#define MII_KSZPHY_CTRL_1 0x1e +#define MII_KSZPHY_CTRL_1 0x1e /* PHY Control 2 / PHY Control (if no PHY Control 1) */ -#define MII_KSZPHY_CTRL_2 0x1f -#define MII_KSZPHY_CTRL MII_KSZPHY_CTRL_2 +#define MII_KSZPHY_CTRL_2 0x1f +#define MII_KSZPHY_CTRL MII_KSZPHY_CTRL_2 /* bitmap of PHY register to set interrupt mode */ #define KSZPHY_CTRL_INT_ACTIVE_HIGH BIT(9) #define KSZPHY_RMII_REF_CLK_SEL BIT(7)
This patch changes the indention to one space between "#define" and the macro. Signed-off-by: Oleksij Rempel <o.rempel@pengutronix.de> --- drivers/net/phy/micrel.c | 24 ++++++++++++------------ 1 file changed, 12 insertions(+), 12 deletions(-)