@@ -54,7 +54,7 @@ __weak void mxsfb_system_setup(void)
*/
static void mxs_lcd_init(struct udevice *dev, u32 fb_addr,
- struct ctfb_res_modes *mode, int bpp)
+ struct display_timing *timings, int bpp)
{
struct mxs_lcdif_regs *regs = (struct mxs_lcdif_regs *)MXS_LCDIF_BASE;
uint32_t word_len = 0, bus_width = 0;
@@ -70,14 +70,14 @@ static void mxs_lcd_init(struct udevice *dev, u32 fb_addr,
return;
}
- ret = clk_set_rate(&per_clk, PS2KHZ(mode->pixclock) * 1000);
+ ret = clk_set_rate(&per_clk, timings->pixelclock.typ);
if (ret < 0) {
dev_err(dev, "Failed to set mxs clk: %d\n", ret);
return;
}
#else
/* Kick in the LCDIF clock */
- mxs_set_lcdclk(MXS_LCDIF_BASE, PS2KHZ(mode->pixclock));
+ mxs_set_lcdclk(MXS_LCDIF_BASE, timings->pixelclock.typ / 1000);
#endif
/* Restart the LCDIF block */
@@ -115,25 +115,25 @@ static void mxs_lcd_init(struct udevice *dev, u32 fb_addr,
mxsfb_system_setup();
- writel((mode->yres << LCDIF_TRANSFER_COUNT_V_COUNT_OFFSET) | mode->xres,
- ®s->hw_lcdif_transfer_count);
+ writel((timings->vactive.typ << LCDIF_TRANSFER_COUNT_V_COUNT_OFFSET) |
+ timings->hactive.typ, ®s->hw_lcdif_transfer_count);
writel(LCDIF_VDCTRL0_ENABLE_PRESENT | LCDIF_VDCTRL0_ENABLE_POL |
LCDIF_VDCTRL0_VSYNC_PERIOD_UNIT |
LCDIF_VDCTRL0_VSYNC_PULSE_WIDTH_UNIT |
- mode->vsync_len, ®s->hw_lcdif_vdctrl0);
- writel(mode->upper_margin + mode->lower_margin +
- mode->vsync_len + mode->yres,
+ timings->vsync_len.typ, ®s->hw_lcdif_vdctrl0);
+ writel(timings->vback_porch.typ + timings->vfront_porch.typ +
+ timings->vsync_len.typ + timings->vactive.typ,
®s->hw_lcdif_vdctrl1);
- writel((mode->hsync_len << LCDIF_VDCTRL2_HSYNC_PULSE_WIDTH_OFFSET) |
- (mode->left_margin + mode->right_margin +
- mode->hsync_len + mode->xres),
+ writel((timings->hsync_len.typ << LCDIF_VDCTRL2_HSYNC_PULSE_WIDTH_OFFSET) |
+ (timings->hback_porch.typ + timings->hfront_porch.typ +
+ timings->hsync_len.typ + timings->hactive.typ),
®s->hw_lcdif_vdctrl2);
- writel(((mode->left_margin + mode->hsync_len) <<
+ writel(((timings->hback_porch.typ + timings->hsync_len.typ) <<
LCDIF_VDCTRL3_HORIZONTAL_WAIT_CNT_OFFSET) |
- (mode->upper_margin + mode->vsync_len),
+ (timings->vback_porch.typ + timings->vsync_len.typ),
®s->hw_lcdif_vdctrl3);
- writel((0 << LCDIF_VDCTRL4_DOTCLK_DLY_SEL_OFFSET) | mode->xres,
+ writel((0 << LCDIF_VDCTRL4_DOTCLK_DLY_SEL_OFFSET) | timings->hactive.typ,
®s->hw_lcdif_vdctrl4);
writel(fb_addr, ®s->hw_lcdif_cur_buf);
@@ -154,11 +154,11 @@ static void mxs_lcd_init(struct udevice *dev, u32 fb_addr,
writel(LCDIF_CTRL_RUN, ®s->hw_lcdif_ctrl_set);
}
-static int mxs_probe_common(struct udevice *dev, struct ctfb_res_modes *mode,
+static int mxs_probe_common(struct udevice *dev, struct display_timing *timings,
int bpp, u32 fb)
{
/* Start framebuffer */
- mxs_lcd_init(dev, fb, mode, bpp);
+ mxs_lcd_init(dev, fb, timings, bpp);
#ifdef CONFIG_VIDEO_MXS_MODE_SYSTEM
/*
@@ -224,6 +224,7 @@ void *video_hw_init(void)
char *penv;
void *fb = NULL;
struct ctfb_res_modes mode;
+ struct display_timing timings;
puts("Video: ");
@@ -280,7 +281,9 @@ void *video_hw_init(void)
printf("%s\n", panel.modeIdent);
- ret = mxs_probe_common(NULL, &mode, bpp, (u32)fb);
+ video_ctfb_mode_to_display_timing(&mode, &timings);
+
+ ret = mxs_probe_common(NULL, &timings, bpp, (u32)fb);
if (ret)
goto dealloc_fb;
@@ -334,7 +337,6 @@ static int mxs_video_probe(struct udevice *dev)
struct video_uc_platdata *plat = dev_get_uclass_platdata(dev);
struct video_priv *uc_priv = dev_get_uclass_priv(dev);
- struct ctfb_res_modes mode;
struct display_timing timings;
u32 bpp = 0;
u32 fb_start, fb_end;
@@ -347,17 +349,7 @@ static int mxs_video_probe(struct udevice *dev)
if (ret)
return ret;
- mode.xres = timings.hactive.typ;
- mode.yres = timings.vactive.typ;
- mode.left_margin = timings.hback_porch.typ;
- mode.right_margin = timings.hfront_porch.typ;
- mode.upper_margin = timings.vback_porch.typ;
- mode.lower_margin = timings.vfront_porch.typ;
- mode.hsync_len = timings.hsync_len.typ;
- mode.vsync_len = timings.vsync_len.typ;
- mode.pixclock = HZ2PS(timings.pixelclock.typ);
-
- ret = mxs_probe_common(dev, &mode, bpp, plat->base);
+ ret = mxs_probe_common(dev, &timings, bpp, plat->base);
if (ret)
return ret;
@@ -378,8 +370,8 @@ static int mxs_video_probe(struct udevice *dev)
return -EINVAL;
}
- uc_priv->xsize = mode.xres;
- uc_priv->ysize = mode.yres;
+ uc_priv->xsize = timings.hactive.typ;
+ uc_priv->ysize = timings.vactive.typ;
/* Enable dcache for the frame buffer */
fb_start = plat->base & ~(MMU_SECTION_SIZE - 1);
struct display_timings provides more informations such clock and DE polarity, so let's refactor the code to use struct display_timings instead of struct ctfb_res_modes, so we'll become able to get clock and DE polarity settings and set register according to them in the next patch. Signed-off-by: Giulio Benetti <giulio.benetti at benettiengineering.com> --- drivers/video/mxsfb.c | 54 ++++++++++++++++++------------------------- 1 file changed, 23 insertions(+), 31 deletions(-)