@@ -36,6 +36,7 @@ struct spi_gpio {
struct gpio_desc *miso;
struct gpio_desc *mosi;
struct gpio_desc **cs_gpios;
+ bool has_cs;
};
/*----------------------------------------------------------------------*/
@@ -205,7 +206,7 @@ static void spi_gpio_chipselect(struct spi_device *spi, int is_active)
gpiod_set_value_cansleep(spi_gpio->sck, spi->mode & SPI_CPOL);
/* Drive chip select line, if we have one */
- if (spi_gpio->cs_gpios) {
+ if (spi_gpio->has_cs) {
struct gpio_desc *cs = spi_gpio->cs_gpios[spi->chip_select];
/* SPI chip selects are normally active-low */
@@ -223,12 +224,10 @@ static int spi_gpio_setup(struct spi_device *spi)
* The CS GPIOs have already been
* initialized from the descriptor lookup.
*/
- if (spi_gpio->cs_gpios) {
- cs = spi_gpio->cs_gpios[spi->chip_select];
- if (!spi->controller_state && cs)
- status = gpiod_direction_output(cs,
- !(spi->mode & SPI_CS_HIGH));
- }
+ cs = spi_gpio->cs_gpios[spi->chip_select];
+ if (!spi->controller_state && cs)
+ status = gpiod_direction_output(cs,
+ !(spi->mode & SPI_CS_HIGH));
if (!status)
status = spi_bitbang_setup(spi);
@@ -279,8 +278,12 @@ static void spi_gpio_cleanup(struct spi_device *spi)
* floating signals. (A weak pulldown would save power too, but many
* drivers expect to see all-ones data as the no slave "response".)
*/
-static int spi_gpio_request(struct device *dev, struct spi_gpio *spi_gpio)
+static int spi_gpio_request(struct device *dev,
+ struct spi_gpio *spi_gpio,
+ unsigned int num_chipselects)
{
+ int i;
+
spi_gpio->mosi = devm_gpiod_get_optional(dev, "mosi", GPIOD_OUT_LOW);
if (IS_ERR(spi_gpio->mosi))
return PTR_ERR(spi_gpio->mosi);
@@ -293,6 +296,13 @@ static int spi_gpio_request(struct device *dev, struct spi_gpio *spi_gpio)
if (IS_ERR(spi_gpio->sck))
return PTR_ERR(spi_gpio->sck);
+ for (i = 0; i < num_chipselects; i++) {
+ spi_gpio->cs_gpios[i] = devm_gpiod_get_index(dev, "cs",
+ i, GPIOD_OUT_HIGH);
+ if (IS_ERR(spi_gpio->cs_gpios[i]))
+ return PTR_ERR(spi_gpio->cs_gpios[i]);
+ }
+
return 0;
}
@@ -303,55 +313,44 @@ static const struct of_device_id spi_gpio_dt_ids[] = {
};
MODULE_DEVICE_TABLE(of, spi_gpio_dt_ids);
-static int spi_gpio_probe_dt(struct platform_device *pdev,
- struct spi_master *master)
+static int spi_gpio_probe_dt(struct platform_device *pdev)
{
- master->dev.of_node = pdev->dev.of_node;
- master->use_gpio_descriptors = true;
-
- return 0;
-}
-#else
-static inline int spi_gpio_probe_dt(struct platform_device *pdev,
- struct spi_master *master)
-{
- return 0;
-}
-#endif
-
-static int spi_gpio_probe_pdata(struct platform_device *pdev,
- struct spi_master *master)
-{
- struct device *dev = &pdev->dev;
- struct spi_gpio_platform_data *pdata = dev_get_platdata(dev);
- struct spi_gpio *spi_gpio = spi_master_get_devdata(master);
- int i;
+ int ret;
+ u32 tmp;
+ struct spi_gpio_platform_data *pdata;
+ struct device_node *np = pdev->dev.of_node;
+ const struct of_device_id *of_id =
+ of_match_device(spi_gpio_dt_ids, &pdev->dev);
-#ifdef GENERIC_BITBANG
- if (!pdata || !pdata->num_chipselect)
- return -ENODEV;
-#endif
- /*
- * The master needs to think there is a chipselect even if not
- * connected
- */
- master->num_chipselect = pdata->num_chipselect ?: 1;
+ if (!of_id)
+ return 0;
- spi_gpio->cs_gpios = devm_kcalloc(dev, master->num_chipselect,
- sizeof(*spi_gpio->cs_gpios),
- GFP_KERNEL);
- if (!spi_gpio->cs_gpios)
+ pdata = devm_kzalloc(&pdev->dev, sizeof(*pdata), GFP_KERNEL);
+ if (!pdata)
return -ENOMEM;
- for (i = 0; i < master->num_chipselect; i++) {
- spi_gpio->cs_gpios[i] = devm_gpiod_get_index(dev, "cs", i,
- GPIOD_OUT_HIGH);
- if (IS_ERR(spi_gpio->cs_gpios[i]))
- return PTR_ERR(spi_gpio->cs_gpios[i]);
+
+ ret = of_property_read_u32(np, "num-chipselects", &tmp);
+ if (ret < 0) {
+ dev_err(&pdev->dev, "num-chipselects property not found\n");
+ goto error_free;
}
+ pdata->num_chipselect = tmp;
+ pdev->dev.platform_data = pdata;
+
+ return 1;
+
+error_free:
+ devm_kfree(&pdev->dev, pdata);
+ return ret;
+}
+#else
+static inline int spi_gpio_probe_dt(struct platform_device *pdev)
+{
return 0;
}
+#endif
static void spi_gpio_put(void *data)
{
@@ -363,11 +362,22 @@ static int spi_gpio_probe(struct platform_device *pdev)
int status;
struct spi_master *master;
struct spi_gpio *spi_gpio;
+ struct spi_gpio_platform_data *pdata;
struct device *dev = &pdev->dev;
struct spi_bitbang *bb;
- const struct of_device_id *of_id;
+ bool use_of = 0;
- of_id = of_match_device(spi_gpio_dt_ids, &pdev->dev);
+ status = spi_gpio_probe_dt(pdev);
+ if (status < 0)
+ return status;
+ if (status > 0)
+ use_of = 1;
+
+ pdata = dev_get_platdata(dev);
+#ifdef GENERIC_BITBANG
+ if (!pdata || (!use_of && !pdata->num_chipselect))
+ return -ENODEV;
+#endif
master = spi_alloc_master(dev, sizeof(*spi_gpio));
if (!master)
@@ -377,17 +387,22 @@ static int spi_gpio_probe(struct platform_device *pdev)
if (status)
return status;
- if (of_id)
- status = spi_gpio_probe_dt(pdev, master);
- else
- status = spi_gpio_probe_pdata(pdev, master);
+ spi_gpio = spi_master_get_devdata(master);
- if (status)
- return status;
+ spi_gpio->cs_gpios = devm_kcalloc(dev,
+ pdata->num_chipselect,
+ sizeof(*spi_gpio->cs_gpios),
+ GFP_KERNEL);
+ if (!spi_gpio->cs_gpios)
+ return -ENOMEM;
- spi_gpio = spi_master_get_devdata(master);
+ platform_set_drvdata(pdev, spi_gpio);
+
+ /* Determine if we have chip selects connected */
+ spi_gpio->has_cs = !!pdata->num_chipselect;
- status = spi_gpio_request(dev, spi_gpio);
+ status = spi_gpio_request(dev, spi_gpio,
+ pdata->num_chipselect);
if (status)
return status;
@@ -405,9 +420,13 @@ static int spi_gpio_probe(struct platform_device *pdev)
}
master->bus_num = pdev->id;
+ /* The master needs to think there is a chipselect even if not connected */
+ master->num_chipselect = spi_gpio->has_cs ? pdata->num_chipselect : 1;
master->setup = spi_gpio_setup;
master->cleanup = spi_gpio_cleanup;
-
+#ifdef CONFIG_OF
+ master->dev.of_node = dev->of_node;
+#endif
bb = &spi_gpio->bitbang;
bb->master = master;
bb->chipselect = spi_gpio_chipselect;
This reverts commit 249e2632dcd0509b8f8f296f5aabf4d48dfd6da8. After this commit drivers/net/dsa/vitesse-vsc73xx.c stopped working. Apparently CS is not working because the reads from the device is just returning just 1:s or just 0:s at all bisection points, so it is a complete regression and I think spi-gpio CS is essentially broken. The revert had to be hand-crafted to preserve all the other cleanup and changes to this driver, but now it works. I'm sad to revert the change because it is a nice cleanup but with the short time before v5.2 is released this is probably the best idea, so we can figure out the right way to do this in the next kernel cycle. Fixes: 249e2632dcd0 ("spi: gpio: Don't request CS GPIO in DT use-case") Cc: Andrey Smirnov <andrew.smirnov@gmail.com> Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- drivers/spi/spi-gpio.c | 137 +++++++++++++++++++++++------------------ 1 file changed, 78 insertions(+), 59 deletions(-) -- 2.21.0