| Message ID | 20180427114723.2687-1-kishon@ti.com |
|---|---|
| Headers | show |
| Series | mmc: sdhci-omap: Add UHS/HS200 mode support | expand |
* Ulf Hansson <ulf.hansson@linaro.org> [180503 08:53]: > On 2 May 2018 at 16:55, Tony Lindgren <tony@atomide.com> wrote: > > * Ulf Hansson <ulf.hansson@linaro.org> [180502 13:17]: > >> On 27 April 2018 at 13:47, Kishon Vijay Abraham I <kishon@ti.com> wrote: > >> > Add UHS/HS200 mode support in sdhci-omap. The programming sequence > >> > for voltage switching, tuning is followed from AM572x TRM > >> > http://www.ti.com/lit/ug/spruhz6j/spruhz6j.pdf > >> > (Similar to all AM57x/DRA7x SoCs). The patch series also implements > >> > workaround for errata published in > >> > http://www.ti.com/lit/er/sprz429l/sprz429l.pdf > >> > > >> > patches are created on top of > >> > git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc.git next > >> > > >> > The patches along with dt has also been pushed to > >> > https://github.com/kishon/linux-wip.git sdhci_uhs_v5 > >> > >> Thanks, applied for next! > > > > OK. Ulf, can I use some commit id from your next as a base for > > the related dts changes? > > > > No, I am re-basing my next branch from time to time so it's not a good idea. > > Instead I have shared an immutable branch for your to pull/merge: > git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc.git sdhci_omap > > I also signed the top commit on this branch: sdhci-omap-v4.17-rc3 > > The branch is based on 4.17-rc3. OK great, thanks a lot! Tony -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html
Add UHS/HS200 mode support in sdhci-omap. The programming sequence for voltage switching, tuning is followed from AM572x TRM http://www.ti.com/lit/ug/spruhz6j/spruhz6j.pdf (Similar to all AM57x/DRA7x SoCs). The patch series also implements workaround for errata published in http://www.ti.com/lit/er/sprz429l/sprz429l.pdf patches are created on top of git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc.git next The patches along with dt has also been pushed to https://github.com/kishon/linux-wip.git sdhci_uhs_v5 Changes from v4: *) Added comment in sdhci for disabling HS200/HS400 mode *) Fixed a couple of chunks in "Program a relatively accurate SW timeout value" which were missed in the previous revision *) Added a patch in sdhci-omap to get IODelay values of 3.3v DDR mode. *) Added pinctrl binding documentation for sdhci-omap which was missed before. Changes from v3: *) Fixed Adrian's comment on error handling when __sdhci_add_host() fails *) Used Adrian's patches for programming SW timeout value. Changes from v2: *) Patches in v2 already applied to mmc -next are dropped from the series. *) Changed SW timeout logic as per Adrians's suggestion *) Validated SDIO with the current patches (added a couple of fixes found while adding SDIO support). *) Used soc_device_match() instead of pdata-quirks as per Tony's suggestions. Changes from v1: *) Only poll on DAT0 and DATI for card_busy status *) Cleanup iodelay patch as suggested by Tony. *) Added quirk to disable HW timeout *) Use the existing data timer but program a relatively accurate SW timeout value (Impacts all platforms) *) Fix a bug in sdhci which was using data_timer for non data line commands Adrian Hunter (2): mmc: sdhci: Add quirk to disable HW timeout mmc: sdhci: Factor out target_timeout calculation Kishon Vijay Abraham I (12): mmc: sdhci-omap: Fix when capabilities are obtained from SDHCI_CAPABILITIES reg mmc: sdhci-omap: Remove setting ADMA capability in driver mmc: sdhci-omap: Workaround for Errata i843 mmc: sdhci-omap: Invoke sdhci_get_of_property to read sdhci dt properties mmc: sdhci: Disable 1.8v modes (HS200/HS400/UHS) if controller can't support 1.8v mmc: sdhci: Program a relatively accurate SW timeout value mmc: sdhci-omap: Workaround for Errata i834 dt-bindings: sdhci-omap: Add K2G specific binding mmc: sdhci-omap: Add support for MMC/SD controller in k2g SoC mmc: sdhci-omap: Add sdhci_omap specific ops for enable_sdio_irq dt-bindings: sdhci-omap: Add pinctrl bindings mmc: sdhci-omap: Get IODelay values for 3.3v DDR mode .../devicetree/bindings/mmc/sdhci-omap.txt | 7 + drivers/mmc/host/sdhci-omap.c | 92 +++++++++-- drivers/mmc/host/sdhci.c | 148 ++++++++++++++---- drivers/mmc/host/sdhci.h | 15 ++ include/linux/mmc/host.h | 4 + 5 files changed, 226 insertions(+), 40 deletions(-) -- 2.17.0 -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html